Vehicle climate control system Ford Focus 1
Climate control specifications
Lubricants, working fluids, sealants and adhesives Position Specification Refrigerant R134a WSH-M17B19-A Cooling oil WSH-M1C231-B Ford Brand A/C System Flush Solvent...
Lubricants, working fluids, sealants and adhesives Position Specification Refrigerant R134a WSH-M17B19-A Cooling oil WSH-M1C231-B Ford Brand A/C System Flush Solvent...
Description and operating principle of microclimate control
Air distribution and purification A new heating and ventilation system has been developed to ensure uniform air distribution. The distribution valves are controlled by a...
Air distribution and purification A new heating and ventilation system has been developed to ensure uniform air distribution. The distribution valves are controlled by a...
Diagnostics and checks (cars manufactured before 07.2001)
Inspection and verification 1. Check the validity of the customer's complaint. 2. Visually inspect for any obvious mechanical or electrical damage. Visual inspection...
Inspection and verification 1. Check the validity of the customer's complaint. 2. Visually inspect for any obvious mechanical or electrical damage. Visual inspection...
Pinpoint tests of microclimate control (cars up to 07.2001)
PINPOINT TEST A: AIR CONDITIONING SYSTEM NOT WORKING (HEATER FAN OK) STATES DETAILS/RESULTS/ACTIONS A1: CHECKING THE OPERATION OF THE A/C COMPRESSOR CLUTCH 1 Enter the...
PINPOINT TEST A: AIR CONDITIONING SYSTEM NOT WORKING (HEATER FAN OK) STATES DETAILS/RESULTS/ACTIONS A1: CHECKING THE OPERATION OF THE A/C COMPRESSOR CLUTCH 1 Enter the...
Diagnostics and checks (cars manufactured since 08.2001)
For connection and connector information, refer to Electrical Wiring Diagram 412-00. Diagnostics and checks 1. Check the customer complaint. 2. Visually inspect for any...
For connection and connector information, refer to Electrical Wiring Diagram 412-00. Diagnostics and checks 1. Check the customer complaint. 2. Visually inspect for any...
Pinpoint tests of microclimate control (cars from 08.2001)
PINPOINT TEST E: HEATER FAN NOT WORKING / PARTIALLY NOT WORKING (ONLY CARS WITHOUT EATC) STATES DETAILS/RESULTS/ACTIONS E1: DETERMINING THE CONDITIONS UNDER WHICH A...
PINPOINT TEST E: HEATER FAN NOT WORKING / PARTIALLY NOT WORKING (ONLY CARS WITHOUT EATC) STATES DETAILS/RESULTS/ACTIONS E1: DETERMINING THE CONDITIONS UNDER WHICH A...
Spring Lock Coupling
1. NOTE: Select the special tool appropriate for the line diameter. Install the special tool. Install the special tool so that the inner ring can be guided into the...
1. NOTE: Select the special tool appropriate for the line diameter. Install the special tool. Install the special tool so that the inner ring can be guided into the...
Adjusting the air gap of the air conditioning system clutch
Name Specification Set of spacer washers 1. Check the air gap "A" between the drive plate and the pulley at 60 degree points around the circumference. For more...
Name Specification Set of spacer washers 1. Check the air gap "A" between the drive plate and the pulley at 60 degree points around the circumference. For more...
Finding Leaks Using Fluorescent Dye
Special tool 120W UV lamp or equivalent R-134a Refrigerant Pressure Gauge Kit or Equivalent Fluorescent Dye Injector for R-134a Refrigerant NOTE: Vehicles manufactured...
Special tool 120W UV lamp or equivalent R-134a Refrigerant Pressure Gauge Kit or Equivalent Fluorescent Dye Injector for R-134a Refrigerant NOTE: Vehicles manufactured...
Electronic leak detection
Special tool Automatic Calibrated Halogen Leak Detector or equivalent R-134a Refrigerant Pressure Gauge Kit or Equivalent Refrigerant identifier or equivalent WARNING:...
Special tool Automatic Calibrated Halogen Leak Detector or equivalent R-134a Refrigerant Pressure Gauge Kit or Equivalent Refrigerant identifier or equivalent WARNING:...
Adding cooling oil
CAUTION: Store cooling oil in a closed, airtight container to prevent moisture penetration. NOTE: When replacing the A/C compressor, water separator or refrigerant...
CAUTION: Store cooling oil in a closed, airtight container to prevent moisture penetration. NOTE: When replacing the A/C compressor, water separator or refrigerant...
Handling contaminated refrigerant
CAUTION: Any R134a or R12 refrigerant contaminated with an incompatible refrigerant must be removed from the system using a suitable service unit designed for the...
CAUTION: Any R134a or R12 refrigerant contaminated with an incompatible refrigerant must be removed from the system using a suitable service unit designed for the...
Cleaning the air distribution system
General equipment: Spray gun with hose. Name Specification Odor Eliminator (240 ml) (No TOX 142040) All cars 1. WARNING: Avoid contact with eyes and skin; use gloves and...
General equipment: Spray gun with hose. Name Specification Odor Eliminator (240 ml) (No TOX 142040) All cars 1. WARNING: Avoid contact with eyes and skin; use gloves and...
Refrigerant recovery, vacuuming and refilling of air conditioning systems
Special tool Service unit or equivalent equipment Refrigerant identification device or equivalent equipment 1. CAUTION: Refrigerant identification equipment must be used...
Special tool Service unit or equivalent equipment Refrigerant identification device or equivalent equipment 1. CAUTION: Refrigerant identification equipment must be used...
Air distribution and purification
The new heating and ventilation system ensures uniform air distribution. The temperature control and air distribution flaps are controlled by two drive cables. All...
The new heating and ventilation system ensures uniform air distribution. The temperature control and air distribution flaps are controlled by two drive cables. All...
Air Conditioning Specifications
Air Conditioning (A/C) Compressor Type Air Conditioning (A/C) Compressor FVS 090 Evaporator jet Color Evaporator jet Orange Tightening torque specification Name Nm Pound...
Air Conditioning (A/C) Compressor Type Air Conditioning (A/C) Compressor FVS 090 Evaporator jet Color Evaporator jet Orange Tightening torque specification Name Nm Pound...
Description and operating principle of air conditioning
The air conditioning (A/C) system has an evaporator jet, controlled by a low pressure relay. The refrigerant used is R134a. Cooler circuit Pos. Spare Part No Name 1 -...
The air conditioning (A/C) system has an evaporator jet, controlled by a low pressure relay. The refrigerant used is R134a. Cooler circuit Pos. Spare Part No Name 1 -...
Air conditioning compressor — removal and installation
Name Specification O-ring seals green color Removal 1. Drain the refrigerant from the air conditioning system. For additional information, refer to Section 412-00. 2....
Name Specification O-ring seals green color Removal 1. Drain the refrigerant from the air conditioning system. For additional information, refer to Section 412-00. 2....
Air conditioning compressor (1.6L) — removal and installation
Removal 1. Drain the refrigerant from the air conditioning system. For additional information, refer to Section 412-00. 2. Raise and support the vehicle. Refer to...
Removal 1. Drain the refrigerant from the air conditioning system. For additional information, refer to Section 412-00. 2. Raise and support the vehicle. Refer to...
Clutch and electromagnetic clutch coil
General equipment: Double-support puller. Name Specification Bolt M6 x 30mm Washer Removal All cars 1. Remove the accessory drive belt. Refer to Section 303-05 for...
General equipment: Double-support puller. Name Specification Bolt M6 x 30mm Washer Removal All cars 1. Remove the accessory drive belt. Refer to Section 303-05 for...
Evaporator jet — removal and installation
Special tool Jet removal/installation tool 412-034 (34-004) Spring Lock Coupling Release Tool, 1/2" (Blue) 412-027 (34-001) Remover for damaged jet 412-035 (34-005)...
Special tool Jet removal/installation tool 412-034 (34-004) Spring Lock Coupling Release Tool, 1/2" (Blue) 412-027 (34-001) Remover for damaged jet 412-035 (34-005)...
Suction tank — removal and installation
Special tool 3/4" Refrigerant Line Disconnect Tool (White) 412-040 (34-002) Removal CAUTION: The water separator should only be replaced if moisture has been allowed to...
Special tool 3/4" Refrigerant Line Disconnect Tool (White) 412-040 (34-002) Removal CAUTION: The water separator should only be replaced if moisture has been allowed to...
Low pressure relay — removal and installation
Removal 1. Disconnect the power steering expansion tank from the wheel arch panel and place it to the side. 2. Disconnect the low pressure switch electrical connector....
Removal 1. Disconnect the power steering expansion tank from the wheel arch panel and place it to the side. 2. Disconnect the low pressure switch electrical connector....
Condenser (refrigerator) core — removal and installation
Name Specification O-ring seals green Removal All cars 1. Drain the refrigerant from the air conditioning system. For additional information, refer to Section 412-00. 2....
Name Specification O-ring seals green Removal All cars 1. Drain the refrigerant from the air conditioning system. For additional information, refer to Section 412-00. 2....
High pressure relay — removal and installation
Removal 1. Raise and support the vehicle. Refer to Section 100-02 for additional information. 2. Disconnect the electrical connector of the high pressure switch. 3....
Removal 1. Raise and support the vehicle. Refer to Section 100-02 for additional information. 2. Disconnect the electrical connector of the high pressure switch. 3....
Description and operating principle of controls
Cars without air conditioning Cars without air conditioning have a standard control panel with three knobs. The air recirculation mode is activated by a two-position...
Cars without air conditioning Cars without air conditioning have a standard control panel with three knobs. The air recirculation mode is activated by a two-position...
Microclimate control assemblies — removal and installation
Removal 1. Remove the audio unit. For additional information, refer to Section 415-01. 2. Remove the screws securing the instrument panel console trim. 3. Pull the...
Removal 1. Remove the audio unit. For additional information, refer to Section 415-01. 2. Remove the screws securing the instrument panel console trim. 3. Pull the...
Microclimate control units in assembly (automatic) — removal and installation
Removal 1. Remove the audio unit. For additional information, refer to Section 415-01. 2. Remove the screws securing the instrument panel console trim. 3. Pull the...
Removal 1. Remove the audio unit. For additional information, refer to Section 415-01. 2. Remove the screws securing the instrument panel console trim. 3. Pull the...
Intake air mixing flap drive
Removal 1. Open and detach the glove compartment. 2. NOTE: Access to the servo motor is difficult. Remove the air recirculation flap servomotor. Disconnect the...
Removal 1. Open and detach the glove compartment. 2. NOTE: Access to the servo motor is difficult. Remove the air recirculation flap servomotor. Disconnect the...
Air distribution control cable block
Removal CAUTION: Disconnect the battery ground cable. Refer to Section 414-01 for additional information. 1. Remove the radio/cassette player and CD player (if...
Removal CAUTION: Disconnect the battery ground cable. Refer to Section 414-01 for additional information. 1. Remove the radio/cassette player and CD player (if...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Focus 2
Focus Turnier 1
Focus 1
- General information
- Vehicle device
- Owner's manual
- Faults en route
- Maintenance
- First maintenance
- Second maintenance
- Applications
- Consumables and spare parts
- Auto mechanic tips
- Power unit
- Engine repair
- Engine seal parts
- Cooling system
- Exhaust system
- Supply system
- Clutch
- Car gearbox
- Front wheel drives
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body and coating
- Body elements
- Side doors
- Tailgate
- Salon elements
- Safety system
- Windshield wipers and washers
- Body Care
- Electrical equipment
- Instruments and motors
- Battery and alternator
- Egnition lock
- Engine management
- Headlights and lighting
- Switches and sensors
- Schematic diagrams
Focus Turnier 1
- General information
- Introduction to guide
- Car care
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Fuel injection (gasoline)
- Fuel injection (diesel)
- Ignition system
- Power and exhaust system
- Transmission
- Clutch and drive shafts
- Mechanical gearbox
- Automatic gearbox
- Chassis
- Car suspension
- Steering
- Wheels and tires
- Brake system
- Body
- Exterior
- Interior
- Heating and ventilation
- Electrical equipment
- Equipment and devices
- Lighting and signaling
- Power devices
- Electrical circuits
Focus 1
- General information
- Using the manual
- Identification codes
- Power unit
- Engine
- Engine 1.4/1.6 Zetec-SE
- Engine 1.6/1.8/2.0 Zetec-E
- Engine Duratec ST 2.0 l
- Engine Duratec 8V 1.6 l
- Diesel engine 1.8 l
- Engine cooling
- Fuel supply
- Accessory drive
- Launch system
- Ignition system
- Air and vapor
- Engine management
- Exhaust toxicity
- Exhaust system
- Automatic gearbox
- Clutch
- Mechanical gearbox iB5
- Mechanical gearbox MTX-75
- Mechanical gearbox MT285
- Chassis
- Front suspension
- Rear suspension
- Wheels and tires
- Front axle axles
- Brake system
- Hydraulic brake
- Anti-lock braking system
- Steering
- Body and coating
- Body panels
- Body elements
- Salon elements
- Glass, frames and mechanisms
- Windshield wipers and washers
- Car sunroof
- Seat belts
- Body repairs
- Back elements
- Electrical equipment
- Climate control
- Heating and ventilation
- Instruments and control lamps
- Battery and alternator
- Audio system
- Headlights and lighting
- Power distribution
- Electronic Function Group