Headlights and vehicle lighting system Ford Focus 2
Features of lighting design
Headlights . Automobiles use headlight assemblies that combine low and high beam lamps, a parking light lamp and a turn signal lamp. Fog lights . Vehicles may be...
Headlights . Automobiles use headlight assemblies that combine low and high beam lamps, a parking light lamp and a turn signal lamp. Fog lights . Vehicles may be...
Replacing lamps
To replace headlight bulbs perform the following operations. NOTE: Shown is replacement of the left headlight bulbs. The bulbs in the right headlight are located...
To replace headlight bulbs perform the following operations. NOTE: Shown is replacement of the left headlight bulbs. The bulbs in the right headlight are located...
Headlight replacement
You will need: TORX T25 key, flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the headlight mounting screw. 3. Use a...
You will need: TORX T25 key, flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the headlight mounting screw. 3. Use a...
Replacing the headlight beam corrector
1. Disconnect the wire from the negative terminal of the battery. 2. Remove the headlight ( see "Replacing the headlight" ). 3. Squeeze the four clamps… 4. …and remove...
1. Disconnect the wire from the negative terminal of the battery. 2. Remove the headlight ( see "Replacing the headlight" ). 3. Squeeze the four clamps… 4. …and remove...
Replacing the side turn signal light
1. Disconnect the wire from the negative terminal of the battery. 2. Remove the wheel mudguard ( see "Removing and installing wheel mudguards and fender liners" ). 3....
1. Disconnect the wire from the negative terminal of the battery. 2. Remove the wheel mudguard ( see "Removing and installing wheel mudguards and fender liners" ). 3....
Replacing the rear light
For replacing the rear light of hatchback and station wagon vehicles perform the following operations. You will need a Phillips-head screwdriver. 1. Disconnect the wire...
For replacing the rear light of hatchback and station wagon vehicles perform the following operations. You will need a Phillips-head screwdriver. 1. Disconnect the wire...
Replacing the reverse light
1. Disconnect the wire from the negative terminal of the battery. 2. Press the latch.. 3. …and remove the reversing light from the bumper. 4. Squeeze the latch… 5....
1. Disconnect the wire from the negative terminal of the battery. 2. Press the latch.. 3. …and remove the reversing light from the bumper. 4. Squeeze the latch… 5....
Replacing the fog light
1. Disconnect the wire from the negative terminal of the battery. 2. Press the latch.. 3. …and remove the fog light from the bumper. 4. Squeeze the latch… 5. …disconnect...
1. Disconnect the wire from the negative terminal of the battery. 2. Press the latch.. 3. …and remove the fog light from the bumper. 4. Squeeze the latch… 5. …disconnect...
Replacing an additional brake light
On cars with hatchback and station wagon bodies replace the additional brake light in the following order. You will need a TORX T25 key. 1. Disconnect the wire from the...
On cars with hatchback and station wagon bodies replace the additional brake light in the following order. You will need a TORX T25 key. 1. Disconnect the wire from the...
Replacing license plate lights
The license plate lights are installed in the decorative trim of the trunk lid (tailgate). They can be removed together with the trim ( see "Removing and installing the...
The license plate lights are installed in the decorative trim of the trunk lid (tailgate). They can be removed together with the trim ( see "Removing and installing the...
Replacement of interior light
You will need: flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2. Pry it up with a screwdriver… 3. …and...
You will need: flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2. Pry it up with a screwdriver… 3. …and...
Replacement of the trunk light
NOTE: The trunk light is installed on sedan vehicles. 1. Disconnect the wire from the negative terminal of the battery. 2. Open the trunk. 3. Overcoming the force of the...
NOTE: The trunk light is installed on sedan vehicles. 1. Disconnect the wire from the negative terminal of the battery. 2. Open the trunk. 3. Overcoming the force of the...
Replacing steering column switches
You will need: flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the top… 3. …and the lower part of...
You will need: flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the top… 3. …and the lower part of...
Removing and installing the horn
You will need a 10 mm wrench. 1. Disconnect the wire from the negative terminal of the battery. 2. Squeeze the latch… 3. …and disconnect the wiring harness connector...
You will need a 10 mm wrench. 1. Disconnect the wire from the negative terminal of the battery. 2. Squeeze the latch… 3. …and disconnect the wiring harness connector...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Focus 2
Focus Turnier 1
Focus 1
- General information
- Vehicle device
- Owner's manual
- Faults en route
- Maintenance
- First maintenance
- Second maintenance
- Applications
- Consumables and spare parts
- Auto mechanic tips
- Power unit
- Engine repair
- Engine seal parts
- Cooling system
- Exhaust system
- Supply system
- Clutch
- Car gearbox
- Front wheel drives
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body and coating
- Body elements
- Side doors
- Tailgate
- Salon elements
- Safety system
- Windshield wipers and washers
- Body Care
- Electrical equipment
- Instruments and motors
- Battery and alternator
- Egnition lock
- Engine management
- Headlights and lighting
- Switches and sensors
- Schematic diagrams
Focus Turnier 1
- General information
- Introduction to guide
- Car care
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Fuel injection (gasoline)
- Fuel injection (diesel)
- Ignition system
- Power and exhaust system
- Transmission
- Clutch and drive shafts
- Mechanical gearbox
- Automatic gearbox
- Chassis
- Car suspension
- Steering
- Wheels and tires
- Brake system
- Body
- Exterior
- Interior
- Heating and ventilation
- Electrical equipment
- Equipment and devices
- Lighting and signaling
- Power devices
- Electrical circuits
Focus 1
- General information
- Using the manual
- Identification codes
- Power unit
- Engine
- Engine 1.4/1.6 Zetec-SE
- Engine 1.6/1.8/2.0 Zetec-E
- Engine Duratec ST 2.0 l
- Engine Duratec 8V 1.6 l
- Diesel engine 1.8 l
- Engine cooling
- Fuel supply
- Accessory drive
- Launch system
- Ignition system
- Air and vapor
- Engine management
- Exhaust toxicity
- Exhaust system
- Automatic gearbox
- Clutch
- Mechanical gearbox iB5
- Mechanical gearbox MTX-75
- Mechanical gearbox MT285
- Chassis
- Front suspension
- Rear suspension
- Wheels and tires
- Front axle axles
- Brake system
- Hydraulic brake
- Anti-lock braking system
- Steering
- Body and coating
- Body panels
- Body elements
- Salon elements
- Glass, frames and mechanisms
- Windshield wipers and washers
- Car sunroof
- Seat belts
- Body repairs
- Back elements
- Electrical equipment
- Climate control
- Heating and ventilation
- Instruments and control lamps
- Battery and alternator
- Audio system
- Headlights and lighting
- Power distribution
- Electronic Function Group