Elements of the car interior Ford Focus 2

Removing and installing the front seat
You will need: TORX T50 key, 8 mm socket head. NOTE: The work is shown for the left seat, the right seat is removed in the same way. 1. Disconnect the wire from the...

Removing and installing the rear seat
The cushion and backrest of the rear seat consist of two parts, each of which can be removed separately. The removal of the left parts of the cushion and backrest is...

Removing and installing the floor tunnel lining
The floor tunnel lining consists of three parts: two side parts and a central part. You will need: TORX T25 key, 10 and 13 mm socket heads, Phillips and flat-head...

Removing and installing the outside mirror
You will need: TORX T25 key, 10 mm socket head. NOTE: Left outside mirror removal shown. Right outside mirror removal is similar. 1. Remove the decorative corner door...

Removing and installing the interior mirror
No tools are required to remove the interior rearview mirror. 1. Turn the lock on the mirror support with your finger… 2. …and remove the mirror by sliding it up from...

Instrument panel design
Fig. 11.1 . Instrument panel: a – area for installing the front passenger airbag; 1 – instrument cluster; 2 – storage box; 3 – central instrument panel trim; 4 – switch...

Removing and installing the instrument panel
You will need: TORX keys T20, T25, T55, "10", "12", a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the steering...

Features of the heater and air conditioner
In the Ford Focus, the interior heating and ventilation system is controlled independently from the air conditioning system when performing the function of interior...

Removal and installation of the control unit for the heating (air conditioning) and ventilation system
You will need: TORX T25 key, flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the center instrument panel trim ( see...

Removing and installing the incoming air filter
You will need a 7 mm wrench. NOTE: Instrument panel removed for clarity. 1. Remove the brake and accelerator pedal assembly ( see "Removing and installing the brake...

Replacing handrails
You will need Phillips and flat-head screwdrivers. 1. Fold the handrail down, overcoming the force of its return springs. 2. Pry it off with a screwdriver.. 3. …open the...

Replacing sun visors
You will need a Phillips-head screwdriver. 1. Remove the two screws securing the sun visor bracket… 2. …and remove the visor. 3. Using a screwdriver, pry off the screw...

Removal and installation of interior trim
You will need flat-head and Phillips-head screwdrivers. NOTE: Shown are the removal and installation of trims on the left side of the cabin. The trims on the right side...

Removing and installing trunk trims
You will need: TORX T45 key, flat-head and Phillips-head screwdrivers. NOTE: The trunk trims are shown removed in the reverse order of their installation on the vehicle....