NOTE: The work is shown for the left seat, the right seat is removed in the same way.
1. Disconnect the wire from the negative terminal of the battery.
2. Remove the bolt securing the wiring harness block for the seat heating system, seat belt pretensioner, electric seat adjustment drive, and electric pedal position switch (if equipped on the vehicle)…
3. …and disconnect the block from the seat.
4. Move the seat all the way back. Remove the two front bolts securing the guide rails to the body base.
5. Move the seat forward as far as it will go and remove the two rear bolts securing the guide rails to the base of the body.
6. Remove the seat from the vehicle interior.
7. Install the seat in the reverse order of removal. Apply anaerobic thread locker to the seat mounting bolts before installation.