Removing and installing the front door trim You will need: an 8 mm socket head and a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the decorative corner trim...
Front door glass replacement You will need: TORX T25 key, 10 mm socket head. 1. Raise the glass all the way up. 2. Remove the front door trim ( see "Removing and installing the front door trim" )....
Replacing the front door window regulator The front door window lifters are equipped with an electric drive. This subsection describes only the removal and installation of the electric window lifter itself. The...
Replacing the outside handle and front door lock switch Shown is the replacement of the outside handle and the switch of the left door lock. The handle and the switch of the right door are replaced in the same way. You will...
Replacing the inner handle of the front door lock drive You will need a TORX T20 key. 1. Remove the front door trim ( see "Removing and installing the front door trim" ). 2. Remove the screw securing the inner handle to the...
Replacing the front door lock You will need: TORX T20 and T30 keys. 1. Remove the front door trim ( see "Removing and installing the front door trim" ). 2. Remove the inner handle of the front door...
Replacing the front door opening limiter You will need: TORX T40 and 10 keys. 1. Raise the glass and remove the front door trim ( see "Removing and installing the front door trim" ). 2. Remove the front door...
Removing and installing the front door You will need: TORX T40 and 8 keys, a flat-blade screwdriver. 1. Remove the screw securing the front door opening limiter to the body pillar. 2. Holding the door (it is...
Removing and installing the rear door trim You will need: an 8 mm socket head and a flat-blade screwdriver. 1. Use a screwdriver to move the spring lock of the handle through the gap between the window lift...
Rear door glass replacement You will need a 10mm socket head. 1. Raise the glass all the way up. 2. Remove the rear door trim ( see "Removing and installing rear door trim" ). 3. Remove the plugs...
Replacing the rear door window regulator You will need: a 10 mm wrench and a flat-blade screwdriver. 1. Remove the rear door trim ( see "Removing and installing rear door trim" ). 2. Remove the rear door glass...
Replacing the outer rear door handle Shown is the replacement of the outer handle of the left door. The handle of the right door is replaced in a similar manner. You will need a TORX T20 key. 1. Open the...
Replacing the rear door lock You will need: TORX T20 and T30 keys. 1. Remove the rear door trim ( see "Removing and installing rear door trim" ). 2. Remove the inner handle of the rear door lock...
Replacing the rear door opening limiter You will need: TORX T40 and 10 keys. 1. Raise the glass and remove the rear door trim ( see "Removing and installing rear door trim" ). 2. Remove the rear door window...
Removing and installing the rear door You will need: TORX T40 and 8 keys, a flat-blade screwdriver. 1. Open the front door to gain access to the rear door wiring harness connector and disconnect the vehicle...