1. Raise the glass all the way up.
2. Remove the front door trim (see "Removing and installing the front door trim").
3. Remove the corner trim mounting screw…
4. …and detach it from the door panel, overcoming the elastic resistance of the piston (shown by the arrow).
5. Remove the outside mirror wiring harness connector from the bracket on the corner trim and remove the trim…
6. …squeeze the clamps…
7. …and disconnect the block.
8. Remove the inner window sill trim, overcoming the elastic resistance of its spring holders.
9. Remove the plugs of the two technological holes from the base of the windshield wiper.
10. Holding the glass, unscrew the rear… through the technological holes
11. …and the front bolts securing the glass clip to the window lifter rocker arm…
WARNING: Be careful not to drop the frame mounting bolts inside the door, otherwise you will have to remove the window regulator to get them out of the door cavity.
12. …and remove the glass from the door by pulling it upwards and turning it in the door opening, as shown in the photo.
13. Install the front door glass and all removed parts in the reverse order of removal.
[The article was taken in its entirety from the specified website: FORDBOOK.ru]