Car accessory drive Ford Focus 1

Accessory Drive Specifications

Tightening torque specification Name Nm pound-foot pound-inch Accessories drive belt tensioner mounting nuts (1.6L Zetec-SE/1.4L engine) 25 18 - Accessory Drive Belt...

Description and operating principle of the accessory drive

Cars with 1.6L Zetec-SE/1.4L engine without air conditioning Pos. Spare Part No Name 1 - Accessory Drive Belt 2 - Intermediate pulley 3 - Generator pulley 4 - Power...

Diagnostics and checks of accessory drive

Inspection and verification 1. Check the validity of the customer's complaint. 2. Visually inspect for obvious signs of mechanical damage. Visual inspection table...

Accessory Drive Belt — Removal and Installation

Removal All cars 1. Disconnect the ground cable from the battery. For additional information, refer to Section 414-01. 2. Raise and support the vehicle. Refer to Section...

Accessory drive belt without tensioner

General equipment: Knife. Removal 1. Raise and support the vehicle. Refer to Section 100-02 for additional information. 2. Remove the crankshaft pulley splash shield. 3....

Accessory Drive Belt Tensioner — Removal and Installation

Removal All cars 1. Remove the accessory drive belt. For more information, refer to the Accessory Drive Belt chapter in this section. Cars with 1.4L or 1.6L engine (100...

Accessory Drive Belt Tensioner (1.8L Diesel)

Removal 1. Remove the power steering pump. Refer to Section 211-02 for additional information. 2. Disconnect the power steering fluid reservoir and secure it to the...

Accessory Drive Belt Idler Pulley

General equipment: Rolling jack Wooden block Removal All cars 1. Remove the accessory drive belt. For more information, refer to the Accessory Drive Belt chapter in this...

Accessory Drive Belt Idler Pulley (1.8L Diesel)

Removal 1. Remove the accessory drive belt. For more information, refer to the Accessory Drive Belt chapter in this section. 2. Remove the intermediate pulley....

Accessory Drive Belt (1.6L Duratec)

Removal 1. Raise and support the vehicle. Refer to Section 100-02 for additional information. 2. Remove the engine protection. 3. Remove the engine splash guard. 4....

Accessory Drive Belt Tensioner (1.6L Duratec)

Removal 1. Remove the generator. For additional information, refer to Section 414-02. 2. Remove the coolant pipe mounting bracket mounting bolt. 3. Remove the accessory...




Focus 2 
Focus Turnier 1 
Focus 1 
We use cookies to ensure the site works smoothly, remembers your settings, and is convenient for you 🍪