Car engine cooling system Ford Focus 2

Design features of the cooling system

Fig. 5.21 . Engine cooling system: 1 – radiator outlet hose; 2 – liquid hose of the expansion tank; 3 – thermostat; 4 – water pump; 5 – expansion tank; 6 – water jacket...


Replacing the cooling system radiator

The radiator must be replaced if coolant leaks are detected from it. In a workshop equipped with special equipment, the radiator can be checked and repaired. WARNING:...

Removal and installation of the electric fan of the radiator of the…

The electric fan of the cooling system radiator is removed to replace its electric motor. You will need a flat-blade screwdriver. 1. Remove the cooling system radiator (...

Removing and installing the expansion tank

You will need: pliers, a container for draining the coolant. 1. Drain the cooling system ( see "Replacing the coolant" ). 2. Loosen the clamps securing the two steam...

Replacing the water pump

Remove the pump for repair or replacement if noise occurs during its operation, the level of which exceeds the normal level and which occurs when a large radial play of...

Replacing the thermostat

The need to replace the thermostat may arise when the engine temperature is unstable: overheating or insufficient warming up. To check the thermostat on a car, start the...

Removal and installation of the electric motor of the radiator fan of…

You will need an 8mm socket head. 1. Remove the electric fan of the engine cooling system together with the casing ( see "Removing and installing the electric fan of the...

Replacing the additional resistance of the radiator fan of the engine…

You will need a Phillips-head screwdriver. 1. Squeeze the latch… 2. …and disconnect the wiring harness connector from the additional resistance. NOTE: For clarity,...




Focus 2 
Focus Turnier 1 
Focus 1 
We use cookies to ensure the site works smoothly, remembers your settings, and is convenient for you 🍪