Car engine cooling system Ford Taurus 1 and 2

Tightening torque specifications
Drive belt tension see chapter 1. Tightening torque specification Nm foot pounds Coolant drain plugs four-cylinder engine 16.3-24.4 12-18 v6 engine 3.0 L 8.1-13.6 6-10...

Cooling, heating, air conditioning systems
Engine cooling system The Tauras and Sable models are equipped with a forced circulation engine cooling system; it is controlled by a coolant switch mounted on the...

General information about antifreeze
Warning: Avoid contact with skin or painted surfaces of the vehicle. If contact occurs, rinse immediately with plenty of water. Do not store fresh coolant or leave old...

Replacing the thermostat
Removal 1. Disconnect the wire from the negative battery terminal. 2. Place a drain pan under the radiator. 3. Remove the radiator cap, put a piece of rubber hose on the...

Electric fan — description, checking and replacement of elements
Warning: To avoid injury, before working on the engine with the hood open, check the fan for cracks or damage. Do not attempt to repair a fan with damaged blades -...

Removal and installation the radiator
1. Disconnect the negative battery cable. 2. Drain the coolant from the radiator ( see chapter 1 ). 3. Remove the "screen" connected to the upper cross member. 4 Unscrew...

Checking and replacing the cooling system fan thermostat
Note: Make sure the engine is completely cool before starting work. Drain approximately 1 liter (1 quart) of coolant from the radiator as recommended in Chapter 1. 1....

Removal and installation the coolant reservoir
Note: When performing this operation, it is important to prevent coolant and windshield washer fluid from getting on the hood of the car, so it is necessary to plug the...

Checking the water pump
1. A failed water pump can cause overheating and serious engine damage because a faulty pump prevents coolant from flowing through the engine. 2. There are two ways to...

Water pump — removal and installation
Four-cylinder engine Removal 1. Disconnect the negative battery cable. 2. Drain the coolant ( see chapter 1 ). 3. Loosen the hose clamp and disconnect the inlet pipe...

Air conditioning and heating systems maintenance
Air conditioning system Warning: The air conditioning system is under high pressure. Do not loosen hose fittings or move parts until the pressure has been relieved by an...

Removal and installation the heater and air conditioner control unit
For heater or heating - air conditioning systems with mechanical control only Note: This procedure is only performed on vehicles with a heater (without air conditioning)...

Replacing the motor and resistance of the heater and air conditioner
Engine and Fan Assembly 1. Open the glove compartment door, release its latches, and lower the door down. 2. Unscrew the nut securing the recirculation pipe bracket to...

Replacing the heater radiator
Note: Before performing this procedure, the air conditioning system (if equipped) must be discharged, consult a specialist. Disassembly 1. Disconnect the negative...

Removal and installation the air conditioning compressor
Warning 1: Before starting work, discharge the system (contact a specialist). You will need a special tool to disconnect the pipes. Warning 2: Some 1992 models are...

Removal and installation the air conditioner condenser
Warning 1: Before starting work, discharge the air conditioning system (contact a specialist). Warning 2: Some 1992 models are equipped with R134 air conditioning...

Air conditioner accumulator and pressure switch
Warning: R12 type accumulator and pressure switches are similar but cannot be used in R134 systems and vice versa. Pressure switch 1. Disconnect the negative battery...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian