Car clutch and drive shafts Ford Taurus 1 and 2

Specifications
Specifications 4-speed automatic transmission left side 463.65 mm (18.27 in) right side 598.55 mm (23.58 in) 3-speed automatic transmission left side 578 75 mm (22.80...

General information
All cars with manual transmission are equipped with a dry clutch, spring-diaphragm type. The clutch disc has a splined hub moving along the corresponding splines of the...

Checking the clutch operation
Clutch diagnostics a) with the engine running and the brake applied, hold the clutch pedal 12.7 mm (1/2 in) off the floor and shift from 1st to 2nd gear and back several...

Clutch — removal, inspection and installation
Warning: Clutch wear produces asbestos-containing dust that settles on the mechanism components and is extremely harmful to your health. Do not blow it off with...

Thrust bearing and its fork — removal, inspection and installation
Warning: Clutch wear produces asbestos-containing dust that settles on the mechanism components and is extremely harmful to your health. Do not blow it off with...

Removal and installation the clutch cable
Removal 1. Remove the left side of the lower instrument panel. 2. Press back the clutch pedal and secure it in this position so that the adjusting pawl separates from...

Internal starter/clutch switch
Removal 1. Remove the lower left part of the instrument panel. 2. Disconnect the interior switch electrical connector. 3. Remove the clamp from the switch rod (see...

Checking axle drives, CV joints and covers
1. Axle drives, CV joints and boots should be checked regularly and also when the vehicle is lifted. The most common symptom of a failing axle drive or CV joint is...

Removal and installation of axial drives
Warning: If any steering fastener becomes loose or is lost, replace it with a new one immediately and discard the used ones and do not reuse them. Caution: If the right...

Replacement of the axle drive housing and CV joint overhaul
Note: If the CV joint is worn out and requires major repairs (usually due to torn boots), then study all instructions before starting the repair. Preparation 1. Remove...

Replacing differential seals
Caution: When the right and left axle drives are removed at the same time, the differential gears must be supported to prevent them from falling into the housing (except...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian