Car steering Ford Taurus 1 and 2

General information
All models are equipped with power steering. The steering gear is bolted to the subframe and controls the levers via steering rods. The inner ends of the transverse...

Steering wheel — removal and installation
Warning: If your vehicle is equipped with an air bag, do not attempt to remove the steering wheel. Contact a professional. Removal 1. Disconnect the wire from the...

Intermediate shaft — removal and installation
Warning: If suspension or steering fasteners are lost or loosened, they must be replaced with new ones; do not reuse them. Fasteners must be replaced with new ones of...

Steering gear — removal and installation
Warning: If suspension or steering fasteners are lost or loosened, they must be replaced with new ones; do not reuse them. Fasteners must be replaced with new ones of...

Power steering pump — removal and installation
Removal 1. Disconnect the wire from the negative terminal of the battery. 2. Place a pan under the power steering pump. Remove the drive belt ( see chapter 1 ) 3. Using...

Replacing the power steering pump reservoir
1. Remove the power steering pump from the vehicle ( see section 26 ) and place it in a vice, clamping it by the eye of one of the mounting bolts. 2. Remove the high...

Bleeding the power steering system
1. The power steering system should be bled every time the hoses and lines are disconnected to remove air and improve handling. 2. With the front wheels straight and...

Tie rod ends — removal and installation
Warning: If suspension or steering fasteners are lost or loosened, they must be replaced with new ones of the same design, quality and marking. Do not reuse them....

Replacing the steering gear covers
Warning: If suspension or steering fasteners are lost or loosened, they must be replaced with new ones; do not reuse them. Fasteners must be replaced with new ones of...

Wheels and tires — general information
All vehicles covered in this manual are equipped with radial tires with steel or fiberglass cords; dimensions are in metric units (see illustration). Using tires of a...

Front Wheel Alignment — General Information
Only toe-in is subject to adjustment. In accordance with factory service specifications, camber and caster should be measured and checked to detect wear or bending of...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian