Car steering Ford Mondeo 2

General information about steering
All models of cars considered in this manual are equipped with a rack and pinion steering gear and hydraulic power steering. The steering gear is attached to the...

Removing and installing the steering gear
When removing the steering gear, you need to remove the subframe to gain access to the steering mounting bolts. In general, removal and installation on all models under...

Checking the technical condition of the toothed rack cuffs
The toothed rack protruding from the housing is protected on the left and right by rubber cuffs. If dirt and moisture penetrate through a damaged or cracked cuff, then,...

Checking the technical condition of the cuffs and ends of the transverse steering rods
Fig. 241. Fastening the transverse tie rod to the steering gear and transverse tie rod arm: 1 — steering gear; 2 - cuff; 3 — lock nut; 4 — tie rod end; 5 — transverse...

Replacing the steering gear coupling
Remove the steering gear coupling as follows: - disconnect the wire from the negative terminal of the battery; - set the steering wheel to the position corresponding to...

Bleeding the power steering drive
Note: The steering system must use a Ford recommended power steering fluid. A low-pressure pump is usually used to bleed the power steering system, but air can also be...

Replacing the power steering pump
Differences in this work are due to the model of engine installed in the vehicle. Replace the power steering pump on a 16-valve engine as follows: - disconnect the wire...

Removing and installing the steering wheel
Remove the steering wheel as follows: - Disconnect the battery and leave the vehicle for at least 5 minutes to avoid false airbag deployment; - unscrew the two airbag...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Mondeo 4
Mondeo 3
Mondeo 2
Mondeo 1 and 2
Mondeo 1