Car steering Ford Mondeo 1

Steering — design description
The steering system consists of a steering wheel, a steering column, a servo steering gear, and tie rods. The steering wheel is mounted on a steering shaft, which is...

Removing and installing the steering wheel
Note: A dirty or sticky steering wheel can be cleaned with a neutral household cleaner and warm water, do not use cleaning agents containing abrasives. Removal Place the...

Adjusting the steering wheel position
The steering wheel position needs to be adjusted if the deviation from the horizontal position is less than 30°. If the deviation is more than 30°, the steering wheel...

Removing and installing the steering rod end
Removal Mark the position of the wheels on the hub with paint so that they can be installed in the same place during assembly. Loosen the wheel nuts on the lowered car....

Removing and installing rubber steering cuffs
Removal Remove the tie rod end. Remove the clamps from both sides of the cuff. Cut the clamps with nippers or loosen the screw clamps. Replace the wire clamps with screw...

Removing and installing the power steering pump
The power steering pump (servo pump) is located on the left front side of the engine. The pump is driven by a V-belt that drives the generator and air conditioning...

Bleeding the hydraulic steering system
Air in the hydraulic system makes the power steering ineffective. It can enter the hydraulic system during repairs, or when the oil level in the receiver drops to such...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Mondeo 4
Mondeo 3
Mondeo 2
Mondeo 1 and 2
Mondeo 1