Car engine cooling system Ford Mondeo 2

General information about the cooling system
The cooling system is designed to maintain normal thermal conditions for the operation of units and mechanisms by removing heat from interacting parts. The cooling...

Replacing the coolant
To replace the coolant in the cooling system: - disconnect the wire from the negative terminal of the battery; - place the front of the car on supports; - remove the...

Replacing the radiator cooling fan
To replace the radiator cooling fan on a 16-valve engine: - remove the radiator (see below); - unscrew the fan casing; - remove the fan. Carry out installation in...

Replacing the radiator
4.4.1. Checking the radiator cap and radiator Warning: When you remove the wire from the negative terminal of the battery, the memory of the electronic storage devices...

Checking the radiator cap and radiator
The cooling system operates under pressure. The expansion tank cap opens when the pressure rises to a certain value (the designation "140" means 140 kPa). To test the...

Replacing the liquid pump
To replace the liquid pump on a 16-valve engine: - remove the timing belt timing belt; - disconnect the wire from the "–" terminal of the battery, observing safety...

Replacing the thermostat
To replace the thermostat on a 16-valve engine: - disconnect the wire from the "–" terminal of the battery; - place the front of the vehicle on supports and drain the...

Checking the Thermostat
Fig. 130. Checking the thermostat"s functionality To check the thermostat's functionality, tie a piece of wire to it and lower it into a container filled with water...

Thermostat malfunctions
Thermostat does not open Cause : the valve plate is jammed or "stuck". Signs : the temperature indicator is already beyond the red mark, but the radiator is still cold...

Checking the cooling system
Check the operation of the cooling system regularly - the reliability of the engine depends on it. To check the cooling system: - check the tightness of all hoses and...

Cooling system hoses
Use cooling system hoses ordered according to engine number. To replace the coolant hose: - drain the coolant from the system; - unscrew the screws at the mounting...

Radiator of the cooling system
The radiator is designed to cool the liquid. It is located in the front of the car and is secured with bolts on both sides. To remove it, you need to remove the shock...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Mondeo 4
Mondeo 3
Mondeo 2
Mondeo 1 and 2
Mondeo 1