Car engine cooling system Ford Mondeo 1 and 2

Technical requirements and tightening torques
Coolant Mixture type see here Filling capacity see Chapter 1 Pressure in the system Pressure check 1.2 bar (must be maintained for at least 10 seconds) Expansion tank...

General information about cooling, heating and air conditioning
Engine cooling system All engines presented in this manual have a closed cooling system with coolant circulation under thermostat control. The coolant pump is mounted on...

General information about antifreeze
Warning: Do not allow antifreeze to come into contact with your skin or the vehicle's paintwork. Any spills should be washed off immediately with water. Antifreeze is...

Disconnecting and replacing cooling system hoses
Note: See warning in paragraph 1 this chapter. 1. If, as a result of the check described in chapter 1 , it turns out that any hose is faulty, then it must be replaced as...

Removing, checking and installing the thermostat
Note: See warning in paragraph 1 this chapter. Removal 1. Disconnect the negative battery cable (Chapter 5, paragraph 1). 2. Drain the cooling system ( chapter 1 ). If...

Removing and installing an electric radiator fan
Note: See warning in paragraph 1 this chapter. Examination 1. The radiator fan of the cooling system operates under the control of the electronic control unit of the...

Removing and installing cooling system sensors
Note: See warning in paragraph 1 this chapter. Coolant Temperature Gauge Sensor 1. On 4-cylinder engines, the sensor is installed on the thread at the left end of the...

Removing and installing the radiator and expansion tank
Note: See warning in paragraph 1 this chapter. Radiator Removal Note: If you are removing your radiator due to leaks, please note that small leaks can often be sealed...

Removing and installing the cooling system pump
Note: See warning in paragraph 1 this chapter. Examination 1. A pump failure can cause serious damage to the engine due to overheating. 2. There are three ways to check...

Removal and installation of heating/ventilation system components
Heater motor Removal 1. Disconnect the negative battery cable (Chapter 5, paragraph 1). 2. Release the four clips (pulling them out) securing the passenger footwell...

Heater/Air Conditioning Control Units
Heater control unit 1. Disconnect the negative battery cable (Chapter 5, paragraph 1). 2. Remove the ashtray (see Chapter 11) and pull out the cigarette lighter trim....

Air conditioning system
General information The air conditioning system comprises a condenser mounted in front of the radiator, an evaporator mounted next to the heat exchanger, a compressor...

Removal and installation of air conditioning system components
Warning: The air conditioning system is under high pressure. Do not loosen connections or remove components until the pressure in the system has been relieved....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Mondeo 4
Mondeo 3
Mondeo 2
Mondeo 1 and 2
Mondeo 1