Sedan rear suspension Ford Mondeo 2

Rear suspension (sedan body)
Fig. 208. Rear suspension assembly (the reaction rods are shown in Fig. 209): 1 — shock absorber strut bearing; 2 - sheet steel plate; 3 - coil spring; 4 — shock...

Removing and installing the rear suspension assembly
Note: All rubber parts of the rear suspension are tightened only under load. Like the front subframe, the rear crossmember must be precisely aligned when removed. To do...

Removing and installing the front trailing arm
The fuel tank must first be removed in order to remove the front trailing arm. Since it is difficult to drain the fuel from the tank, a pump will be required to pump it...

Removing and installing the rear trailing arm
Fig. 212. Installing the rear trailing arm mounting bolts The fuel tank does not need to be removed for this job. After the rear of the vehicle is on the lift, unscrew...

Removing and installing the anti-roll bar
If you only need to remove the stabilizer, the crossmember can be left on the car. For this job, raise the rear of the car. Remove the anti-roll bar as follows: -...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Mondeo 4
Mondeo 3
Mondeo 2
Mondeo 1 and 2
Mondeo 1