Exterior (external body parts) Ford Mondeo 1

General information about the car body
The body of FORD MONDEO cars is a self-supporting structure. The bottom, side parts and roof are welded to each other. Major body repairs can only be carried out in...

Removing and installing the front bumper
Removal Disconnect the negative (-) cable from the battery. Warning! This will erase data in electronic memory devices, such as the engine fault memory device or the...

Removing and installing the rear bumper
Removal Raise the car Remove the rear muffler mount, lower the rear of the exhaust system and support it, see item 8 . Remove the right and left bumper/wheel arch...

Removing and installing the front mudguard
Removal Mark the position of the wheels on the hub with paint so that they can be installed in the same place during assembly. Loosen the wheel nuts on the lowered car....

Removing and installing the radiator grille
Removal Open the engine hood. Unscrew the two T30 bolts "2" securing the radiator grille "1". Unlatch the grille from below the "arrow" and remove it. Installation...

Removing and installing the air grille
Removal Remove the windshield wiper arms, see item 23.1 . Unscrew the upper mounting bolts, having first removed the plugs with a small screwdriver. Open the engine...

Removing and installing the outside mirror
Removal Disconnect the negative (-) cable from the battery. Warning! This will erase data in electronic memory devices, such as the engine fault memory device or the...

Replacing moldings
Apply self-adhesive tape tightly to the molding being replaced at the top and bottom. This will protect the paintwork from damage when removing the molding. It will also...

Removing and installing the engine hood
Removal Open and secure the engine hood. Disconnect the negative (-) cable from the battery. Warning! This will erase data in electronic memory devices, such as the...

Removing and installing the hood lock drive cable
Removal Disconnect the negative (-) cable from the battery. Warning! This will erase data in electronic memory devices, such as the engine fault memory or radio code....

Removing and installing the hood lock
Removal Disconnect the negative (-) cable from the battery. Warning! This will erase data in electronic memory devices, such as the engine fault memory device or the...

Straightening and varnishing works
Straightening and varnishing work on a car body requires knowledge of the material and its processing. Such knowledge is acquired over many years of practice. Therefore,...

Repairing damage from rock strikes
To avoid major repairs caused by rust, minor damage to the paintwork should be repaired regularly. To remove small scratches and stone impact marks that only damage the...

Elimination of body deformation and removal of corrosion pits
Small pits can be repaired with a straightening hammer and a suitable hand anvil. In case of pits in the bodywork from rust, it is recommended to replace the damaged...

Preparing the body for varnishing
Wash the car before varnishing. Varnishing should be carried out only at temperatures above +12°C, avoiding direct sunlight and wind. Rust removal Cover the repair area...

The process of varnishing the car body
To avoid problems during the varnishing process, the pre-applied Primer should be made by the same company as the aerosol varnish. In this case, the varnish will not...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Mondeo 4
Mondeo 3
Mondeo 2
Mondeo 1 and 2
Mondeo 1