Engine ignition system car Ford Mondeo 1 and 2

Technical requirements and tightening torques
Technical requirements and tightening torques
Ignition timing Denomination 10 ±2° before TDC Note: The ignition timing is controlled by the ECU. It can be changed at idle and is not adjustable. Ignition coil Output...

General information and precautions
General information and precautions
General information The ignition system includes the ignition switch, battery, crankshaft position/speed sensor, ignition coil, primary (low voltage) and secondary (high...

Checking the ignition system
Checking the ignition system
Warning: Due to the high voltages that are generated in the ignition system, extreme caution must always be exercised when servicing components of the ignition system....

Checking, removing and installing the ignition coil
Checking, removing and installing the ignition coil
Warning: See paragraph 2 . Examination 1. Check if battery voltage is supplied to the center contact of the ignition coil electrical connector ( see paragraph 2 )....

Removing and installing the ignition module
Removing and installing the ignition module
Note: Automatic transmission models only. Removal 1. Disconnect the negative battery cable ( chapter 1 ). 2. If necessary, remove the resonator to improve access...

Checking the ignition timing
Checking the ignition timing
1. The ignition timing is controlled entirely by the ECU. (On models with automatic transmission, the ECU controls a separately installed ignition module). Therefore,...




Mondeo 4 
Mondeo 3 
Mondeo 2 
Mondeo 1 and 2 
Mondeo 1