Car engine cooling system Ford Mondeo 4

Cooling system
Fig. 5.58. Cooling system: 1 – expansion tank cap; 2 – heater supply hose; 3 – heater outlet hose; 4 – distributor housing; 5 – radiator supply hose; 6 – radiator; 7 –...

Replacing the coolant
According to the manufacturer's recommendation, the coolant should be replaced after 100 thousand km of mileage or 5 years of operation (whichever comes first). You will...

Replacing the cooling system radiator
The radiator must be replaced if a coolant leak is detected. In a workshop with special equipment, the radiator can be checked and repaired. WARNING: Remove the radiator...

Replacing the water pump
Fig. 5.59. Water pump of the Duratec Ti-VCT engine with a volume of 1.6 l: A – tension roller of the timing belt; B - water pump; B – bolts for fastening the water pump...

Removing and installing the thermostat
Fig. 5.60. Thermostat: 1 – radiator outlet hose; 2, 6, 8 – clamps; 3 – thermostat housing mounting bolts; 4 – thermostat housing sealing gaskets; 5 – thermostat housing;...

Removing and installing the expansion tank
1. Unscrew the expansion tank cap. 2. Pump out the coolant from the expansion tank. 3. Squeeze the fastening clips of the steam outlet hose and the throttle body heating...

Checking the level and adding coolant
You will need: coolant, funnel, clean cloth. RECOMMENDATION: The manufacturer recommends using ethylene glycol-based coolant (antifreeze). Check with your dealer -...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Mondeo 4
Mondeo 3
Mondeo 2
Mondeo 1 and 2
Mondeo 1