Doors, locks and windows of the car Ford Mondeo 4

Removing and installing the front door trim

You will need: TORX T20 key, flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2. Pry off the hole plug in the...

Front door glass replacement

You will need: TORX T25 key, 8 mm socket head, flat-blade screwdriver. 1. Raise the glass all the way up. 2. Remove the front door trim ( see Removing and installing...

Replacing the front door window regulator

The front door window lifters are equipped with an electric drive. This subsection describes only the removal and installation of the electric window lifter itself. The...

Replacing the outside handle and front door lock switch

Shown is the replacement of the outside handle and the switch of the left door lock. The handle and the switch of the right door are replaced in the same way. You will...

Replacing the inner handle of the front door lock drive

You will need: TORX T20 key, flat-blade screwdriver. 1. Remove the front door trim ( see Removing and installing front door trim ). 2. Remove the fastening screw from...

Replacing the front door lock

You will need: TORX T20 and T30 keys, a flat-blade screwdriver. 1. Remove the front door trim ( see Removing and installing front door trim ). 2. Remove the inner door...

Replacing the front door opening limiter

You will need: a 10 mm socket head and a 13 mm wrench. The front door opening limiter mechanism is installed in the upper door hinge. To replace it, follow these steps....

Removing and installing the front door

You will need: 8mm and 10mm socket heads, a flat-blade screwdriver. 1. Holding the door (it is best if an assistant does this), unscrew the bolts-axles of the lower…...

Removing and installing the rear door trim

You will need: TORX T20 key, flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2. Pry up the hole plug in the...

Rear door glass replacement

You will need: 7 mm keys, TORX T20, flat-blade screwdriver. 1. Raise the glass all the way up. 2. Remove the rear door trim ( see Removing and installing rear door trim...

Replacing the rear door window regulator

You will need: TORX T25 key. 1. Remove the rear door trim ( see Removing and installing rear door trim ). 2. Remove the rear door glass ( see Rear Door Glass Replacement...

Replacing the outer rear door handle

Shown is the replacement of the outer handle of the left door. The handle of the right door is replaced in a similar manner. You will need a TORX T20 key. 1. Open the...

Replacing the inner handle of the rear door lock actuator

You will need a TORX T20 key. 1. Remove the rear door trim ( see Removing and installing rear door trim ). 2. Remove the fastening screw from the piston of the inner...

Replacing the rear door lock

You will need: TORX T20 and T30 keys, a flat-blade screwdriver. 1. Remove the rear door trim ( see Removing and installing rear door trim ). 2. Remove the inner handle...

Replacing the rear door opening limiter

You will need: a 13 mm wrench and a 10 mm socket head. The rear door opening limiter mechanism is installed in the upper door hinge. To replace it, follow these steps....

Removing and installing the rear door

You will need: 8 and 10 mm socket heads, a flat-blade screwdriver. 1. Holding the door (it is best if an assistant does this), unscrew the bolts-axles of the lower…...




Mondeo 4 
Mondeo 3 
Mondeo 2 
Mondeo 1 and 2 
Mondeo 1 
We use cookies to ensure the site works smoothly, remembers your settings, and is convenient for you 🍪