Removal and installation of an upholstery of a back door

You will need: T20 TORX wrench, flat and Phillips screwdrivers.

1. Disconnect a wire from the minus plug of the storage battery.



2. Pry off the hole plug in the lining of the inner handle of the lock and remove it.



3. Turn out the screw of fastening of facing of the handle of the lock.



4. Gently prying off the handle lining with a screwdriver, disengage it from the door upholstery and, pressing the lock handle, remove the lining of the inner lock handle moving forward.




5. Pressing the latch..



6.... disconnect the wiring harness connector from the rear door power window switch connector and remove the lining of the inner lock handle.



7. Having prying off the decorative trim of the armrest handle with a screwdriver and overcoming the resistance of the latches, remove the trim.




8. Turn out two screws of fastening of the handle of an armrest to the internal panel of a door.



9. Turn out on an end face of a door screws of top..



10.... and the lower fastenings of the door upholstery.



11. Having overcome resistance of holders, separate an upholstery from the internal panel of a door.

NOTE: This is how the rear door trim holders are located. Replace damaged holders.

12. Pressing the latch..



13.... disconnect the wiring harness connector from the speaker connector of the speaker system and remove the rear door upholstery.

14. Establish an upholstery of a back door and all removed details in an order, the return to removal.