Car clutch repair Ford Mondeo 2

General information about the clutch
The clutch is designed for short-term disconnection and subsequent smooth connection of the engine and transmission. Mondeo cars use a single-plate dry clutch with a...

Checking the clutch
To check the operation of the clutch (with the parking brake in good condition), do the following: - apply the parking brake to the car; - start the engine; - engage...

Removing the clutch
To remove the clutch, follow these steps: - remove the gearbox; - mark the position of the clutch relative to the flywheel on the clutch housing cover and the outer side...

Clutch installation
Installation is carried out in reverse order, taking into account the following: Fig. 148. Centering the driven disk from the inside of the clutch - to center the driven...

Removing and installing the clutch master cylinder
First, you need to remove the electronic engine control unit. To remove the master cylinder, follow these steps: - disconnect the wire from the negative terminal of the...

Removing and installing the clutch hydraulic drive slave cylinder
The cylinder is installed with a sealant, the sealing ring is replaced with a new one. To remove the slave cylinder, perform the following operations: Fig. 152....

Bleeding the Clutch Hydraulic Drive
Bleeding is done in the same way as for the brakes, but the bleed hose is put on the threaded plug of the working cylinder after removing the boot. After bleeding the...

Adjusting the free travel of the clutch pedal
To adjust the clutch pedal free play: - turn the steering wheel to the left by approximately 30° from the center position; Fig. 155. Measuring pedal free travel: 1 —...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Mondeo 4
Mondeo 3
Mondeo 2
Mondeo 1 and 2
Mondeo 1