Vehicle wheel drive shafts Ford Mondeo 1 and 2

Technical requirements and tightening torques

Tightening torques for connections Name Nm Bolts for fastening the connecting link of the anti-roll bar to the suspension strut 47 Bolts for fastening the support...

General information about drive shafts

1. Torque is transmitted from the transmission differential to the front wheels via two drive shafts. The right drive shaft is two-section and contains a support bearing...

Removing and installing drive shafts

Removal 1. Remove the wheel cap. Apply the parking brake and engage first gear or set the selector to position "P". Loosen the hub nut by about half a turn. It is...

Inner CV joint cover of the drive shaft

1. To replace the boot, you need to disconnect the drive shaft from the inner constant velocity joint housing on the transmission side (left shaft) or from the...

Outer CV joint cover of the drive shaft

1. The outer hinge cover can be replaced in two ways: by first removing the inner cover ( paragraph 3 ) or by first removing the entire drive shaft assembly ( paragraph...

Inspection and replacement of drive shaft joints

1. If the checks described in Chapter 1 indicate excessive wear or play in any of the drive shaft joints, remove the wheel cover and make sure that the hub nut (outer...

See other similar sections for Ford cars:
• Transmission: Drive shafts Ford Escort 3 (1980-1985)



Mondeo 4 
Mondeo 3 
Mondeo 2 
Mondeo 1 and 2 
Mondeo 1 
We use cookies to ensure the site works smoothly, remembers your settings, and is convenient for you 🍪