Car headlights and lighting Ford Mondeo 4

Lighting, light and sound signaling
Lighting, light and sound signaling
Headlights. Ford Mondeo vehicles use headlight assemblies that combine low and high beam headlights (with single-filament bulbs) and direction indicators. In addition,...
There are 1 a comment

Replacing lamps
Replacing lamps
WARNING: Before replacing bulbs in vehicle lighting devices, disconnect the cable from the negative terminal of the battery. For replacement headlight bulbs perform the...

Removing and installing the multifunctional electronic unit (gem)
Removing and installing the multifunctional electronic unit (gem)
The multi-function electronic unit (GEM) is installed on the right under the instrument panel, under the glove compartment. NOTE: Shown with instrument panel removed for...

Headlight replacement
Headlight replacement
The headlight is removed if it is damaged and to gain access to other units. The internal elements of the headlight are not supplied separately as spare parts,...

Replacing the fog light
Replacing the fog light
You will need an 8 mm wrench. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the front wheel arch liner on the side of the fog lamp bulb...

Replacing the rear light
Replacing the rear light
The rear light consists of two parts, one of which is fixed to the body, and the second to the trunk lid (tailgate). You will need a 10 mm wrench. To replace the rear...

Replacing an additional brake light
Replacing an additional brake light
You will need a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the trunk lid trim by unscrewing the trim fastening...

Replacing the side turn signal light
Replacing the side turn signal light
No tools are required to replace the side turn signal light. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the side turn signal light from...

Replacing license plate lights
Replacing license plate lights
You will need a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Using a screwdriver, press the spring clip of the license...

Replacement of interior light
Replacement of interior light
You will need a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Pry up the lampshade diffuser with a screwdriver… 3….and...




Mondeo 4 
Mondeo 3 
Mondeo 2 
Mondeo 1 and 2 
Mondeo 1