Lighting, light and sound signaling Ford Fusion

Features of the lighting and signaling design
Headlights . Automobiles use headlights that combine a dual-filament low-beam and high-beam lamp, a parking light lamp, and a turn signal lamp. Fog lights . Vehicles may...

Replacing lamps in lighting fixtures
To replace the low and high beam lamp in the headlight perform the following operations. 1. Disconnect the wire from the negative terminal of the battery. 2. Pry up the...

Headlight replacement
You will need: a flat-blade screwdriver or a TORX T25 key. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the front bumper (see " Removal...

Replacing the side turn signal light
1. Disconnect the wire from the negative terminal of the battery. 2. Remove the front wheel arch liner (see " Removal and installation wheel mudguards and fender liners...

Front Fog Light Replacement
You will need a TORX T25 key. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the front wheel arch liner (see " Removal and installation...

Replacing the rear light
You will need a TORX T25 key. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the rear pillar trim (see " Removal and installation trunk...

Replacing an additional brake light
You will need a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the rubber plugs. 3. Press the clips located in the...

Replacing license plate lights
You will need a TORX T20 key. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the two mounting screws… 3. …and remove the diffuser from the...

Replacing the front interior light
You will need: flat-head and Phillips-head screwdrivers. 1. Disconnect the wire from the negative terminal of the battery. 2. Use a screwdriver to press the lampshade...

Replacing the rear interior light
You will need a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Overcoming the resistance of the clamps, remove the...

Replacement of the trunk light
You will need a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Use a screwdriver to pry up the lampshade retainer and...

Replacing steering column switches
You will need a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the upper part of the steering column cover (see "...

Removal and installation the horn
You will need a 10 mm wrench. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the front bumper (see " Removal and installation the front...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Fusion
Scorpio 1
Scorpio 2
Sierra