Car rear suspension Ford Scorpio 2
General information about the rear suspension
FORD SCORPIO cars have a rear axle with independent wheel suspension on diagonal levers. The axle is suspended by two coil springs and hydraulic shock absorbers. The...
FORD SCORPIO cars have a rear axle with independent wheel suspension on diagonal levers. The axle is suspended by two coil springs and hydraulic shock absorbers. The...
Removal and installation the propeller shaft
Removal Raise the car onto jack stands. Remove the exhaust system, see p. 80 . Vehicles with catalytic converter: Remove heat shield from underbody. Models from 9/94,...
Removal Raise the car onto jack stands. Remove the exhaust system, see p. 80 . Vehicles with catalytic converter: Remove heat shield from underbody. Models from 9/94,...
Removal and installation the rear shock absorber
If the vehicle's mileage is more than 10,000 km, then for safety reasons, shock absorbers should only be replaced in pairs. Checking the shock absorber is described on...
If the vehicle's mileage is more than 10,000 km, then for safety reasons, shock absorbers should only be replaced in pairs. Checking the shock absorber is described on...
Removal and installation the stabilizer
Removal Raise the rear of the car onto jack stands. Use a screwdriver to detach the stabilizer at the top left and right from the connecting rod. Unscrew the bolts...
Removal Raise the rear of the car onto jack stands. Use a screwdriver to detach the stabilizer at the top left and right from the connecting rod. Unscrew the bolts...
Removal and installation the rear wheel hub
Removal Remove the wheel cap and loosen the hub shaft nut. Note: The car must be parked with its wheels on the platform. Loosen the rear wheel mounting nuts on the...
Removal Remove the wheel cap and loosen the hub shaft nut. Note: The car must be parked with its wheels on the platform. Loosen the rear wheel mounting nuts on the...
Removal and installation the wheel hub bearing
Removal Remove the wheel hub. Using a screwdriver, remove the radial seals -A, E- from the hub "C". Remove both tapered roller bearings -B, D-. Knock out the bearing...
Removal Remove the wheel hub. Using a screwdriver, remove the radial seals -A, E- from the hub "C". Remove both tapered roller bearings -B, D-. Knock out the bearing...
Removal and installation the rear axle propeller shaft
Removal Raise the rear of the car onto jack stands. Loosen the fastening of the cardan shaft to the drive flange. Loosen the fastening of the cardan shaft to the flange...
Removal Raise the rear of the car onto jack stands. Loosen the fastening of the cardan shaft to the drive flange. Loosen the fastening of the cardan shaft to the flange...
Disassembling the cardan shaft, replacing the corrugated covers
A damaged bellows should be replaced immediately, as water and dirt penetrate through it, destroying the joint. To replace the boot, the cardan shaft must be...
A damaged bellows should be replaced immediately, as water and dirt penetrate through it, destroying the joint. To replace the boot, the cardan shaft must be...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Fusion
Scorpio 1
Scorpio 2
Sierra
- General information
- Vehicle device
- User manual
- Faults on the way
- Maintenance
- Tips for the car owner
- Power unit
- Engine repair
- Lubrication and cooling system
- Supply system
- Exhaust and vapor recovery
- Transmission
- Clutch
- Car gearbox
- Front wheel drives
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body
- Exterior
- Interior
- Doors, locks and windows
- Body сare
- Electrical equipment
- Equipment and devices
- Engine electrics
- Lighting and signaling
- Switches and sensors
- Electrical circuits
Scorpio 1
- General information
- User manual
- Maintenance
- Power unit
- Petrol engines OHC
- Petrol engines DOHC
- Petrol engines V6
- Ignition and control
- Diesel engines
- Cooling system
- Supply system
- Carburetors
- Fuel injection
- Transmission
- Clutch
- Manual gearbox «N»
- Manual gearbox «MT 75»
- Automatic gearbox «A4LD»
- Rear axle and drive shafts
- Chassis
- Steering
- Power steering
- Front suspension
- Rear suspension
- Brake system
- Body
- Exterior
- Interior
- Doors, locks and windows
- Heating and ventilation
- Electrical equipment
- Equipment and devices
- Power devices
- Electrical circuits
Scorpio 2
- General information
- Car care
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Ignition system
- Supply system
- Carburetors
- Injection system (gasoline)
- Injection system (diesel)
- Exhaust system
- Transmission
- Clutch
- Car gearbox
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body
- Exterior
- Interior
- Doors, locks and windows
- Heating system
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Windshield wipers and washers
- Power devices
- Electrical circuits
Sierra
- General information
- User manual
- Maintenance
- Gasoline engines
- Engine repair
- Ignition system
- Fuel system
- Cooling and lubrication system
- Changes 1984-1986
- Changes 1987-1989
- Changes 1990-1993
- Diesel engines
- Engine repair
- Fuel system
- Cooling and lubrication system
- Changes 1988-1993
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Cardan and rear axle
- Chassis
- Steering
- Steering with power steering
- Front suspension
- Rear suspension
- Brake system
- Body and electrical
- Body elements and doors
- Electrical equipment
- Electrical circuits