Car engine ignition system Ford Sierra

Technical characteristics of the ignition system
The ignition system is battery-powered, transistor-based and includes: ignition distributor with contactless sensor with Hall transducer; ignition coil; switch; spark...

Ignition system — general information
The ignition system, transistorized and using the Hall effect, provides a constant voltage and spark energy in all engine operating modes. The ignition system consists...

Hall Effect Pulse Sensor
Operating principle of a pulse sensor with a Hall transducer A and B are control electrodes, H is the direction of the magnetic field (perpendicular to the surface), E...

Ignition Distribution — Design Description
Bosch Ignition Distributor 1 – housing, 2 – drive shaft, 3 – coil and plate with fixed contacts, 4 – rotor, 5 – vacuum regulator, 6 – dust cover, 7 – distributor rotor,...

Ignition system switch
Switch The switch serves to amplify the signal that occurs at the moment the Hall effect disappears, controls the interruption of the primary circuit of the ignition...

Notes on the operation of the ignition system
The transistor ignition system has more energy in the high voltage circuit than the classic ignition system. While the engine is running, do not touch the elements of...

Setting the ignition timing
Control signs for setting the ignition timing angle 1 – constant sign, 2 – TDC sign of the piston of the 1st cylinder on the pulley 1. Connect the strobe lamp in...

Ignition System Fault Identification
The transistor ignition system should be checked with a well-charged battery and at a temperature of 0° to -40°C. The instructions below should be followed. The starter...

Removal and installation the ignition distributor
Lucas Ignition System 1 – ignition coil, 2 – ignition switch, 3 – ignition distributor housing, 4 – drive gear, 5 – ignition distributor shaft, 6 – Hall sensor, 7 –...