Vehicle electrical equipment Ford Sierra

Technical characteristics of on-board electrical equipment
Battery A 12 V battery with a capacity of 35 Ah (270 A/50 RC), 43 Ah (360 A/60 RC) or 54 Ah (500 A/75 RC) is used. The negative pole of the battery is connected to the...

Relays and fuses
Relay The following relays may be installed in the main fuse and relay box: NI: safe engine starting (starter interlock) in vehicles with automatic transmission.; N II:...

Removal and installation the generator
Removal the generator 1 – wire connection, 2 – lower mounting bolts Removal 1. Disconnect the ground wire from the battery and also the multi-pin connector on the back...

Disassembly and assembly of the generator
Removal the generator A – Bosch, B – Lucas, C – Motorola 35 A and 45 A, D – Motorola 55 A and 70 A. 1 – pulley and fan, 2 – front cover, 3 – rotor, 4 – bearing, 5 –...

Adjusting the V-belt tension
Attention! In cars with hydraulic power steering there are two V-belts that are tensioned simultaneously. 1. Loosen the generator mounting bolts. 2. Tilt the generator...

Starter — design description
Starter mount 1 – bolts for fastening the starter to the clutch housing, 2 – starter power supply wire, 3 – electromagnetic switch power supply wire Lucas Starters 1 –...

Windscreen wiper, indicator assembly and headlights
Windscreen wiper 1 – engine, 2 – holder, 3 – rods, 4 – wiper arm axles, 5 – wiper arm, 6 – brush Removal the windshield wiper motor 1. Turn on the windshield wiper and...

Removal and installation the instrument cluster
Instrument cluster A – basic version, L and GL, B – Ghia version, 1 – printed circuit board, 2 – case, 3 – casing, 4 – glass, 5 – speedometer, 6 – fuel level and coolant...

Headlight adjustment
Headlight adjustment screws A – all versions except Ghia, B – Ghia version Fuse and relay box 1–20 – fuse designations (see table. List of fuses ). The headlight beam...

Heating and ventilation system — removal and installation
Car heating and ventilation system 1 – heater, 2 – heater housing, 3 – air dampers, 4 – control unit, 5 – fan housing, 6 – fans Heater housing 1 – fastening nut, 2 –...

Fan Motor — Removal and Installation
Removal 1. Disconnect the ground cable from the battery. 2. Remove the air chamber seal rubber under the front panel. 3. In the engine compartment, unscrew and remove...