Electrical equipment of the car engine Ford Transit 2

Engine electrical equipment — technical requirements
General information System Type - Negative Grounded Operating voltage: 12 V Battery Type - Lead-acid, low-maintenance or maintenance-free Voltage: "Bad" - 12.5 V...

Engine Electrical Systems — general information and precautions
General information Engine electrical systems include all charging, starting and heating components. Because of their engine-related functions, these components are...

Battery — removal and installation
Removal 1. The battery is located in the engine compartment on the right side or one on each side if two batteries are installed. 2. Note the location of the wires, then...

Charging system — testing
Caution: Before you begin, please refer to the warnings given in the "Safety First!" section and in section 1 . 1. If the alternator battery charge indicator lamp...

Alternator — removal and installation
Removal 1. Disconnect the negative battery cable. 2. Loosen the tension of the alternator and water pump drive belt as described in Chapter 1 . 3. According to the type...

Alternator Brushes and Regulator — inspection and replacement
1. Remove the alternator as described in previous Section . 2. Unscrew the three bolts and remove the vacuum pump from the rear of the generator (see Figure 6.2). Figure...

Launch system — testing
Note: Before you begin, please refer to the warnings given in Section. "Safety first!" and in section 1 . 1. If the starter does not turn at all when the ignition is on,...

Starter — removal and installation
Removal 1. Disconnect the negative battery cable. 2. Disconnect the starter wire from the solenoid and, where applicable, from the threaded pin on the end cap (see...

Starter — replacing brushes
Note: This description describes brush replacement for Lucas/Magneti-Marelli M127 starters. However, the procedures for other starter types are similar. Please refer to...

Low oil pressure sensor — removal and installation
Removal 1. The low oil pressure sensor is installed on the right side of the cylinder block, below the high pressure fuel pump (see Figure 11.1). Figure 11.1. Location...

Engine preheating system — description and testing
Description 1. A preheating system is not typically installed, as the engine starts without it at temperatures down to -20°C (-4°F). However, it can be installed on...

Glow Plug — removal and installation
Removal 1. Disconnect the negative battery cable. 2. Disconnect the voltage supply to the spark plug and unscrew the fuel supply pipe connection. Place the end of the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian