Contents: Removal ↳ Installation ↳
Removal
1. Disconnect the negative battery cable.
2. Disconnect the starter wire from the solenoid and, where applicable, from the threaded pin on the end cap (see figure 8.2,a,b).
Figure 8.2,a. Disconnect the starter wires from the traction relay (indicated by an arrow)...
Figure 8.2,b.... and, on some models, from the threaded pin (indicated by the arrow) on the end cap.
3. Unscrew the three bolts securing the starter. Please note that on some types of motors the ground cable is secured by one of the bolts (see Figure 8.3). Remove the starter from the engine.
Figure 8.3. Unscrew and remove the bolts securing the starter (indicated by arrows), remembering that sometimes the grounding cable is secured with one of the bolts.
Installation
4. Install in the reverse order of removal. Make sure the wires are securely connected.
[For more information, please visit the specified website: Fordbook.ru]