Electrical equipment and devices Ford Transit 2
Vehicle electrical equipment — technical data
Fuses (models before 1992) № Rating (Amps) Protected circuit 1 25 Relay - headlight switch, heater motor 2 10 Direction indicators 3 15 Windshield wiper motor,...
Fuses (models before 1992) № Rating (Amps) Protected circuit 1 25 Relay - headlight switch, heater motor 2 10 Direction indicators 3 15 Windshield wiper motor,...
General information and precautions
The electrical system operates at 12 volts, with the negative terminal connected to ground. Indicator lights, exterior and interior lights, and all other electrical...
The electrical system operates at 12 volts, with the negative terminal connected to ground. Indicator lights, exterior and interior lights, and all other electrical...
Electrical Circuit Troubleshooting — general information
Note: Before starting work, refer to the warnings given in the "Safety First!" section and in section 1 . The following tests concern the testing of basic electrical...
Note: Before starting work, refer to the warnings given in the "Safety First!" section and in section 1 . The following tests concern the testing of basic electrical...
Fuses and relays — general information
Fuses 1. The main fuses, relays and timers are located in the central junction box located below the instrument panel on the driver's side. In addition, recent models...
Fuses 1. The main fuses, relays and timers are located in the central junction box located below the instrument panel on the driver's side. In addition, recent models...
Switches — removal and installation
Multi-function steering column switches 1. The steering column has two multi-function switches. The left switch contains the full beam and flashing headlight switch,...
Multi-function steering column switches 1. The steering column has two multi-function switches. The left switch contains the full beam and flashing headlight switch,...
Instrument cluster (models without tachograph) — removal and installation
Removal Models before 1995 1. Disconnect the negative battery cable. 2. Loosen the retaining screws and remove the steering column covers. 3. Loosen the top nuts...
Removal Models before 1995 1. Disconnect the negative battery cable. 2. Loosen the retaining screws and remove the steering column covers. 3. Loosen the top nuts...
Instrument cluster instruments and bulbs (models without a tachograph) — removal and installation
1. Remove the instrument cluster as described in the previous section. When working with the instrument panel, as well as when removing or installing its elements, try...
1. Remove the instrument cluster as described in the previous section. When working with the instrument panel, as well as when removing or installing its elements, try...
Tachograph — removal and installation
Removal 1. Disconnect the negative battery cable. 2. Loosen the retaining screws and remove the upper and lower covers from the control column. 3. Remove the heater...
Removal 1. Disconnect the negative battery cable. 2. Loosen the retaining screws and remove the upper and lower covers from the control column. 3. Remove the heater...
Fuel and temperature gauge (models with tachograph) — removal and installation
Removal 1. Remove the panel surrounding the instrument cluster as described in Section 7 paragraphs 1-5 inclusive. 2. Push the combined fuel and temperature gauge out of...
Removal 1. Remove the panel surrounding the instrument cluster as described in Section 7 paragraphs 1-5 inclusive. 2. Push the combined fuel and temperature gauge out of...
Control lamp unit (models with tachograph) — removal and installation
Removal 1. Remove the panel surrounding the instrument cluster as described in Section 7 , paragraphs 1-5 inclusive. 2. Using a well-sharpened screwdriver as a lever,...
Removal 1. Remove the panel surrounding the instrument cluster as described in Section 7 , paragraphs 1-5 inclusive. 2. Using a well-sharpened screwdriver as a lever,...
Speedometer Cable — removal and installation
Removal 1. Remove the instrument cluster as described in Section 5 . 2. With the parking brake applied, jack up the front of the vehicle and securely support it on...
Removal 1. Remove the instrument cluster as described in Section 5 . 2. With the parking brake applied, jack up the front of the vehicle and securely support it on...
Cigarette lighter — removal and installation
Removal Models before 1995 1. Disconnect the negative battery cable. 2. Remove the four retaining screws and separate the heater control unit from the front panel enough...
Removal Models before 1995 1. Disconnect the negative battery cable. 2. Remove the four retaining screws and separate the heater control unit from the front panel enough...
Watch — removal and installation
Removal Models before 1995 1. Refer to the procedures given in Section 6 . Models since 1995 2. Disconnect the negative battery cable. 3. Remove the radio (or CD...
Removal Models before 1995 1. Refer to the procedures given in Section 6 . Models since 1995 2. Disconnect the negative battery cable. 3. Remove the radio (or CD...
Checking and adjusting low beam headlights
1. Precise adjustment of headlight beams is only possible with special optical equipment and must be performed by a Ford dealer or a suitably equipped service station....
1. Precise adjustment of headlight beams is only possible with special optical equipment and must be performed by a Ford dealer or a suitably equipped service station....
Exterior Light Bulbs and Parking Lights — replacement
Note: Before disconnecting the wiring connectors to any exterior light bulbs, make sure. that all external lighting devices are turned off. The headlight, front parking...
Note: Before disconnecting the wiring connectors to any exterior light bulbs, make sure. that all external lighting devices are turned off. The headlight, front parking...
Light bulbs (interior lighting) — replacement
Interior body lighting lamps 1. Insert the end of a small screwdriver into the recess in the lamp assembly, carefully pry the lamp assembly up and remove it (see Figure...
Interior body lighting lamps 1. Insert the end of a small screwdriver into the recess in the lamp assembly, carefully pry the lamp assembly up and remove it (see Figure...
External lighting fixtures — removal, installation
Headlights Models before 1992 1. Remove the front turn signal as described later in this Section. 2. Remove the protective cover from the back of the headlight and...
Headlights Models before 1992 1. Remove the front turn signal as described later in this Section. 2. Remove the protective cover from the back of the headlight and...
Horn — removal and installation
Removal 1. The horn is installed on the front of the vehicle under the left headlight behind the radiator grille (see Fig. 17.1). For better access, it is recommended to...
Removal 1. The horn is installed on the front of the vehicle under the left headlight behind the radiator grille (see Fig. 17.1). For better access, it is recommended to...
Windshield wiper arms — removal and installation
Removal 1. Remove the wiper blades ( see Chapter 1 ). 2. Lift the suspended covers and remove the nuts and washers securing the wiper arms to the pivot shafts (see...
Removal 1. Remove the wiper blades ( see Chapter 1 ). 2. Lift the suspended covers and remove the nuts and washers securing the wiper arms to the pivot shafts (see...
Windshield wiper motor and drive mechanism — removal and installation
Removal 1. Disconnect the negative battery cable. 2. Remove the wiper arms as described in previous Section . 3. Unscrew the plastic nut from the windshield wiper arm...
Removal 1. Disconnect the negative battery cable. 2. Remove the wiper arms as described in previous Section . 3. Unscrew the plastic nut from the windshield wiper arm...
Windshield wiper arm pivot shaft housing — removal and installation
Removal 1. Remove the wiper motor with the drive mechanism as described in the previous section. Disconnect the drive mechanism ball joints by prying the ball joint...
Removal 1. Remove the wiper motor with the drive mechanism as described in the previous section. Disconnect the drive mechanism ball joints by prying the ball joint...
Headlight and windshield washer reservoir — removal and installation
Removal 1. Disconnect the multi-plug and washer hose from the pump on the reservoir (see Figure 21.1). Figure 21.1. Detailed view of the windshield and headlight washer...
Removal 1. Disconnect the multi-plug and washer hose from the pump on the reservoir (see Figure 21.1). Figure 21.1. Detailed view of the windshield and headlight washer...
Rear Door Wiper Elements — removal and installation
Removal Windscreen wiper arm and blade 1. Proceed in the same way as when removing and installing the windshield wiper arms and blades ( see section 18 ). Pay attention...
Removal Windscreen wiper arm and blade 1. Proceed in the same way as when removing and installing the windshield wiper arms and blades ( see section 18 ). Pay attention...
Radio and car stereo — removal and installation
Note: The following information only applies to radios and stereos that were originally fitted to your Ford Transit by the manufacturer. Before starting work, please...
Note: The following information only applies to radios and stereos that were originally fitted to your Ford Transit by the manufacturer. Before starting work, please...
CD player — removal and installation
Removal and installation procedures for this unit (if it is installed) identical to those described for the radio in previous Section .
Removal and installation procedures for this unit (if it is installed) identical to those described for the radio in previous Section .
Radio antenna — removal and installation
Removal Roof mounted antenna 1. Contact Chapter 11 and, if necessary, remove the interior trim of the cabin ceiling to gain access to the rear of the antenna. 2. Working...
Removal Roof mounted antenna 1. Contact Chapter 11 and, if necessary, remove the interior trim of the cabin ceiling to gain access to the rear of the antenna. 2. Working...
Power amplifier — removal and installation
Removal 1. This unit can be installed on some Ford Transit models produced since 1995. 2. Before removing the unit, be sure to disconnect the negative battery cable. 3....
Removal 1. This unit can be installed on some Ford Transit models produced since 1995. 2. Before removing the unit, be sure to disconnect the negative battery cable. 3....
Speakers — removal and installation
Removal 1. Remove the appropriate trim panel as described in Chapter 11, sections 9 or 30 , in order to gain access to the speaker. 2. Unscrew the fixing screws and then...
Removal 1. Remove the appropriate trim panel as described in Chapter 11, sections 9 or 30 , in order to gain access to the speaker. 2. Unscrew the fixing screws and then...
Airbags — removal and installation
Removal Driver's airbag 1. Disconnect the negative battery cable. Warning: Before proceeding, wait at least 15 minutes for the energy in the backup capacitor to...
Removal Driver's airbag 1. Disconnect the negative battery cable. Warning: Before proceeding, wait at least 15 minutes for the energy in the backup capacitor to...
Airbag control unit — removal and installation
Removal 1. Disconnect the negative battery cable. 2. Remove the instrument cluster according to the vehicle type as described earlier in this Chapter . 3. Disconnect the...
Removal 1. Disconnect the negative battery cable. 2. Remove the instrument cluster according to the vehicle type as described earlier in this Chapter . 3. Disconnect the...
Passive anti-theft system — general information and replacement of components
General information 1. The Passive Anti-Theft System (PATS) is available on all models produced since 1995. This system will not allow the engine to start until the PATS...
General information 1. The Passive Anti-Theft System (PATS) is available on all models produced since 1995. This system will not allow the engine to start until the PATS...
Possible malfunctions of automotive electronics
Causes of malfunctions Electronic units (EU) include the following devices: microprocessor (CPU); non-volatile program memory (NVM); data memory (RAM), etc. These...
Causes of malfunctions Electronic units (EU) include the following devices: microprocessor (CPU); non-volatile program memory (NVM); data memory (RAM), etc. These...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
See other similar sections for Ford cars:
• General information: Vehicle device Ford Focus 2 (2004-2010)
• Electrical equipment: Equipment and devices Ford Mondeo 1 (1993-1996)
• Electrical equipment: Equipment and devices Ford Escort 4 (1986-1990)
• Electrical equipment: Equipment and devices Ford Scorpio 1 (1985-1994)
• General information: Vehicle device Ford Focus 2 (2004-2010)
• Electrical equipment: Equipment and devices Ford Mondeo 1 (1993-1996)
• Electrical equipment: Equipment and devices Ford Escort 4 (1986-1990)
• Electrical equipment: Equipment and devices Ford Scorpio 1 (1985-1994)
Transit 2
- General information
- User manual
- Maintenance
- Troubleshooting
- Power unit
- Engine in the car
- Engine overhaul
- Cooling and heating
- Fuel and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Cardan and rear axle
- Chassis
- Brake system
- Steering system
- Front suspension
- Body
- Exterior
- Interior
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits