Car doors, locks, and windows Ford Transit 2

Interior door trim — removal and installation
Front doors Removal 1. On pre-1995 models, pry the cover off the window handle, unscrew the retaining screw, and, noting the position of the handle, (with the glass up),...

Front Door Parts — removal and installation
External handle (models before 1995) Removal 1. Remove the door trim ( see previous section ). 2. Through the holes in the inner door panel, unscrew the two Torx screws...

Front door — removal, installation, adjustment
Models before 1995 Removal 1. Open the door and place a jack or wooden block under it, without lifting it, but just to neutralize the weight. 2. Remove the plastic clips...

Sliding Side Door Parts — removal and installation
Pen Removal 1. Remove the inner door trim ( see Section 9 ) 2. Separate the outer handle rod, then unscrew the lock nuts, remove the washers and remove the handle....

Sliding side door — removal, installation and adjustment
Removal 1. Loosen the mounting screw and remove the center guide end stop (see Figure 13.1). Figure 13.1. Loosen the mounting screw and remove the end stop of the...

Rear Door Parts — removal and installation
1. In most cases, you will have to remove the door trim to get to the relevant parts ( for more details see. in Section 9 ). Lock cylinder Removal 2. Separate the lock...

Rear doors — removal, installation and adjustment
Removal 1. Open the rear doors. If you want to remove the left rear door, then remove the inner trim ( Section 9 ). 2. Remove the door opening limiter. Disconnect the...

Tailgate Parts — removal and installation
External handle Removal 1. Disconnect the latch cover or remove the inner trim of the tailgate ( see Section 9 ). 2. Unscrew the handle cover nuts (see Figure 16.2)....

Tailgate — removal and installation
Removal 1. To remove the tailgate you will need two assistants. Open the side of the vehicle and have someone hold it, then disconnect the license plate light wiring and...

Front door window regulator and glass — removal and installation
Models before 1995 Removal 1. Raise the glass and remove the inner door trim ( see Section 9 ). 2. Disconnect the door lock rod retainers from the vertical post (see...

Front door fixed glass — removal and installation
Removal 1. Using a hook, release the side mirror mounting cover, then unscrew and remove the four fasteners. Lift up and remove the mount. 2. Press firmly on the glass...

Sliding glass and frame — removal and installation
Removal 1. Slide the glass so that the window is open. When working in the interior, push out the edge of the glass seal from the top corner and, pulling on the edge,...

Sliding glass and frame — disassembly and assembly
Disassembly 1. Remove the glass in the frame from the window as described in Section 20 , remove the seal and place the glass on a table covered with a clean cloth. 2....

Rear opening window — removal and installation
Removal 1. Loosen and remove the two screws securing the window latch to the pillar, partially open the window and pull on the glass to disengage the window hinge wings....

Windshield and fixed glass — removal and installation
The windshield, rear window, and fixed side windows are installed in their openings using glue containing a special compound. Replacing these glasses requires special...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian