Automatic transmission of car Ford Transit 2

Automatic transmission — technical data
General information Type - Four forward gears and reverse gear, planetary gear with hydraulic control and three-wheel torque converter Designation: Ford A4LD Gear ratios...

Automatic transmission — general information
A four-speed automatic transmission is available as an optional extra on some models. The gear shift lever is centrally mounted and features a T-shaped handle with a...

Brake bands — adjustment
Note: The following procedures require Ford Special Tool #17-029. 1. With the parking brake applied, jack up the front of the vehicle and support it on jack stands. 2....

Downshift cable (kick-down) — regulation
Please note: On vehicles with a long downshift cable, a special Ford tool #17-031 must be used to adjust the cable. This tool is essentially a piece of metal with a fork...

Downshift Cable — removal and installation
Removal 1. With the parking brake applied, jack up the front of the vehicle and support it on jack stands. 2. Release the clips and remove the two-piece lower engine...

Gear Shift Lever Cable — removal, installation and adjustment
Removal 1. Move the gear selector lever to the "N" position. 2. With the parking brake applied, jack up the front of the vehicle and support it on jack stands. 3....

Gear shift mechanism — removal and installation
Removal 1. With the parking brake applied, jack up the front of the vehicle and support it on jack stands. 2. Release the clips and remove the lower engine soundproofing...

Locking switch — removal, installation and adjustment
Removal 1. With the parking brake applied, jack up the front of the vehicle and support it on jack stands. 2. Release the clips and remove the lower engine soundproofing...

Oil seals — replacement
Rear (driven shaft) oil seal 1. The replacement procedure is similar to that described for the N type manual transmission ( see Section 3 of Part A ). Speedometer drive...

Vacuum diaphragm — removal and installation
Removal 1. With the parking brake applied, jack up the front of the vehicle and support it on supports. 2. Release the clips and remove the lower engine soundproofing...

Servomechanism — removal and installation
Removal 1. With the parking brake applied, jack up the front of the vehicle and support it on jack stands. 2. Release the clips and remove the lower engine soundproofing...

Vacuum regulator — testing and adjustment
Please note: a pressure gauge is required for checking and adjusting. Vacuum testing 1. Disconnect the hose from the vacuum diaphragm outlet nipple on the regulator and...

Vacuum regulator — removal and installation
Removal 1. Note the location of the two vacuum hoses on the regulator for proper installation and then disconnect both hoses. 2. Disconnect the rod from the governor...

Speedometer Drive Pinion — removal and installation
Removal 1. With the parking brake applied, jack up the front of the vehicle and support it on jack stands. 2. Unscrew the speedometer cable retaining plate bolt. On...

Automatic transmission — removal and installation
Note: Refer to previous Sections, if necessary, for details on disconnecting accessories and fittings. Removal 1. Remember that internal faults in an automatic...

Automatic transmission overhaul — general information
If a malfunction of the automatic transmission is detected, first of all it is necessary to determine what nature (electric, mechanical or hydraulic) has a malfunction,...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian