Rear (driven shaft) oil seal
1. The replacement procedure is similar to that described for the N type manual transmission (see Section 3 of Part A).
Speedometer drive gear oil seal
2. The replacement procedure is described in Section 13.
Oil seals — replacement (Transit 2)
1. The replacement procedure is similar to that described for the N type manual transmission (see Section 3 of Part A).
2. The replacement procedure is described in Section 13.
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Article reviewed: Afanasy Koshelev
See other similar articles for Ford cars:
• Valve Seals — Removal and Installation Ford Focus 1 (1998-2004)
• Checking the drive shaft seals Ford Mondeo 3 (2000-2007)
• Replacement of springs, retainers, valve seals Ford Taurus 1 and 2 (1986-1994)
• Replacing valve stem seals Ford Fusion (2002-2012)
• Valve Seals — Removal and Installation Ford Focus 1 (1998-2004)
• Checking the drive shaft seals Ford Mondeo 3 (2000-2007)
• Replacement of springs, retainers, valve seals Ford Taurus 1 and 2 (1986-1994)
• Replacing valve stem seals Ford Fusion (2002-2012)
Link to this page in different formats
Visitor comments
No comments yet
Transit 2
- General information
- User manual
- Maintenance
- Troubleshooting
- Power unit
- Engine in the car
- Engine overhaul
- Cooling and heating
- Fuel and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Cardan and rear axle
- Chassis
- Brake system
- Steering system
- Front suspension
- Body
- Exterior
- Interior
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits