Manual gearbox of car Ford Transit 2

Manual transmission — technical data
General part Type - Four or five forward gears and reverse. Forward gears are fully synchronized (on the MT75 gearbox and reverse gear). The overdrive gear is installed...

Manual transmission — general information
The vehicles described in this manual are equipped with either a 4-/5-speed manual or a 4-speed automatic transmission. This section describes manual gearboxes....

Gearbox control lever — removal and installation
G-type gearbox Removal 1. With the parking brake applied, jack up the front of the vehicle and place it on supports. 2. From the cabin side, unscrew the screws securing...

Oil seals — replacement
Front (primary shaft) oil seal Gearboxes of types G and N 1. Remove the gearbox as described in Section 7 . 2. Clean the entire gearbox assembly, paying particular...

Reverse Light Switch — removal and installation
Examination 1. The reverse light circuit is controlled by a short-circuit piston type switch screwed into the side of the transmission. When a fault is detected in a...

Speedometer Drive Gear — removal and installation
Removal 1. With the parking brake applied, jack up the front of the vehicle and support it on stands. 2. On G and N type transmissions, disconnect the speedometer cable...

Manual transmission mounts — inspection and replacement
Inspection 1. Transmission mounts rarely require attention, but if broken or damaged, they should be repaired immediately as additional stress on driveline components is...

Manual transmission — removal and installation
Note: The gearbox can be removed as a unit with the engine as described in Chapter 2B , then separated from the engine on site. However, if repairs are only needed on...

Manual Transmission Overhaul — general information
1. Overhauling a manual transmission is a difficult job for a novice mechanic. It involves removing and installing many small parts. Numerous gaps must be accurately...

Overdrive — general information
Some Ford Transit models with a G-type gearbox are additionally equipped with an overdrive transmission. The overdrive unit is attached to the rear of the gearbox and is...

Overdrive Switch — removal and installation
Removal 1. Disconnect the negative battery cable. 2. Insert a knife blade into the joint between the gear shift button and the button cover, and carefully remove the...

Overdrive Lock Switch — removal and installation
Removal 1. Disconnect the negative battery cable. 2. With the parking brake applied, jack up the front of the vehicle and secure it on supports. 3. After disconnecting...

Overdrive Solenoid Valve — removal and installation
Removal 1. Disconnect the negative battery cable. 2. With the parking brake applied, jack up the front of the vehicle and secure it on supports. 3. Support the gearbox...

Overdrive gear — removal and installation
Warning: The following procedures require the rear of the vehicle to be raised and supported on jack stands with the wheels off the ground. Because this action is...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian