The driveshaft and rear axle of car Ford Transit 2

Cardan shaft and rear axle — technical data
Cardan shaft Type - Two- or three-section with one or two intermediate supports, front, middle and rear universal joints; constant velocity joint or elastic rubber joint...

Driveshaft and rear axle — general information
This chapter discusses the elements of the cardan transmission. For convenience, all these components are combined into two groups, namely the propeller shaft and the...

Cardan shaft — description
Torque is transmitted from the gearbox to the rear axle by a balanced two- or three-link tubular cardan shaft, supported at the center of one (for two-link) or two (for...

Cardan shaft (two links) — removal and installation
Note: New driveshaft coupling flange bolts will be required during installation. Removal Gearboxes without overdrive 1. Block both front wheels, jack up the rear of the...

Cardan shaft (three-section type) — removal and installation
Note: New driveshaft coupling flange bolts will be required during installation. Removal 1. Block both front wheels, jack up the rear of the car and place it on...

Replacement of the center support bearing of the propeller shaft
1. Remove the propeller shaft as described in the section 3 or 4 according to type. 2. Remove the locking tab from the universal joint mounting bolt, then loosen the...

Elastic quibo type hinge — removal and installation
Removal 1. Remove the propeller shaft as described in Section 3 or 4 , depending on its type. 2. Before removing the joint, mark the relative position of the cardan...

Rear Axle — description
On all models, the rear axle is mounted on semi-elliptical leaf springs. Car models before 1992 have single-leaf springs, later models use multi-leaf springs. Two...

Rear axle — removal and installation
Note: The procedures for removing and installing the rear axle are described below, piece by piece. If required, the entire axle, including the wheels and rear springs,...

Rear axle half shafts — removal and installation
Removal Bridge type "H" (mod. 34) 1. After unloading the vehicle, block the front wheels. Remove the wheel caps and loosen the wheel nuts on the side you are interested...

Rear Hub and Bearing (H-Type Axle) — removal, disassembly and installation
Please note: Rear hub fixing methods have changed frequently over the course of production. Review all procedures before you begin work and make sure you have all the...

Rear Hub and Bearing (G-Type Axle) — removal, disassembly and installation
Please note: Rear hub fixing methods have changed frequently over the course of production. Review all procedures before you begin work and make sure you have all the...

Pinion Oil Seals (All Axle Types) — renewal
Please note that on all axle types, the main drive pinion has a collapsible spacer sleeve between the tapered roller bearings of the pinion shaft (see Figure 7.2 and...

Differential housing (type «H») — removal and installation
Please note that on the rear axle type "H" the differential is mounted in the differential housing, which, in turn, is attached with studs to the front side of the rear...

Differential (G-type axle) — overhaul
1. The design and arrangement of the G-type axle is such that any attempt to remove the differential or final drive assembly from the axle housing disrupts their mutual...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

See other similar sections for Ford cars:
• Transmission: Cardan and rear axle Ford Sierra (1982-1993)