Car automatic transmission Ford Fiesta 2

Automatic transmission device
The automatic transmission installed in FORD FIESTA vehicles differs from the automatic transmissions used in vehicles of other manufacturers. Fig. 3.37 shows the...

Removing the automatic transmission
Disconnect the ground wire from the battery clamp. Remove the cam cable fastener. Unscrew the nut (B, Fig. 3.38) and hang the cable. Remove the coolant hose from the...

Installation of automatic transmission
Before starting work, thoroughly clean the splined surfaces of the axle shafts and vibration dampers. Cover the seal with self-adhesive tape, and lubricate the splined...

Checking the oil level
The oil level in the automatic transmission can only be checked when the transmission is at normal operating temperature (+65°C). Therefore, the transmission must be...

Replacing the manual control cable
Set the manual control lever to the "L" position, i.e. for driving in lower gears in difficult road conditions. Unscrew the manual control lever handle and remove the...

Replacing the cam starter cable
Disconnect the ground wire from the battery clamp. Remove the intake noise muffler and the speedometer drive. Unscrew the nut securing the speedometer cable to the...

Replacing the automatic transmission lock switch
Disconnect the vehicle ground cable from the battery clamp. Raise the car. Remove the electrical wire from the switch. Unscrew the switch. Screw in a new switch with a...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Fiesta 4
Fiesta 2