Disassembly and assembly of the car engine Ford Fiesta 2

Description and location of engines
Engines 1.1/1.1i The engine called "Valencia" (Fig. 2.1) is an overhead valve engine with a camshaft placed in the housing and acting on the valves through pushers and...

Removing the engine from the car
The engine is removed together with the gearbox. Before removing the power unit, it is necessary to engage the fourth gear in the gearbox. This will allow you to...

Installing the engine on a car
Adhere to the tightening torques for bolts and nuts specified in Section 1.1. Prepare the power unit for installation. To do this, insert the rod of the right engine...

Disassembling the engine 1.1
Secure the engine to the mounting stand using the 21-050 A holder (Fig. 2.13). Drain the oil from the engine. Unscrew the oil filter. Remove the high voltage wires....

Dismantling 1.4i/1.6i engines (with petrol injection)
Disconnect the engine from the gearbox. Secure the engine to the mounting stand Remove the generator with its casing and belt pulley. Unscrew the oil filter and drain...

Disassembling a 1.8 diesel engine
Remove the exhaust manifold. Secure the engine to the mounting stand. Remove the generator. Remove the starter with the bracket. Unscrew the engine mount bracket. Drain...

Engine assembly — general information
After inspection and replacement of damaged parts, you can begin to assemble the engine. Place the dry main bearing shells in the engine housing. Install the thrust...

Engine assembly 1.1
Install the oil suction tube. Install the chain tensioner. Measure the parallelism of the tensioner cam to the end surface of the engine housing (Fig. 2.30). The...

Assembly of 1.4i/1.6i engines (with petrol injection)
Install the crankshaft axial alignment washer. Install it so that the bulge is on the outside. Lubricate the crankshaft journals and secure the toothed and V-wheels to...

Assembly of diesel engine 1.8
Secure the crankshaft rear oil seal housing to the lower edge of the engine housing (Fig. 2.46). Use a new housing gasket. Install the new seal as follows: generously...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

See other similar sections for Ford cars:
• Engine: Disassembly and assembly Ford Escort 3 (1980-1985)

Fiesta 4
Fiesta 2