Car engine cylinder head Ford Fiesta 2

Inspection of the camshaft of the cylinder head
For inspection, the cylinder head can be removed without removing the engine from the car. All engines (except the 1.1 engine) have camshafts located in the cylinder...

Removing and installing the engine cylinder head 1.1
To remove the head, you must perform the following steps: Disconnect the ground wire from the battery clamp. Remove the air filter. Disconnect the electrical connections...

Removal and installation of cylinder heads of 1.4i/1.6i engines
Removal of the cylinder head is carried out in the following order: Disconnect the ground cable from the battery. On the 1.4i engine, remove the air filter. On the 1.6i...

Removal and installation of the cylinder head of a 1.8 diesel engine
Disconnect the ground wire from the battery clamp. Drain the coolant into a previously prepared container. If the coolant has been in use for no more than two years and...

Disassembling the cylinder head of a gasoline engine
Remove the intake manifold. Remove the exhaust manifold. Remove the ignition distributor. Unscrew the thermostat housing. Unscrew the valve levers (this applies to...

Checking and repairing the cylinder head and its parts
Check the flatness of the cylinder head seating surface. To do this, apply a ruler diagonally to the cylinder head and check the fit of the ruler to the cylinder head...

Checking and repairing the cylinder head of a 1.8 diesel engine
Remove the camshaft. First, unscrew the second and fourth bearing caps. Then unscrew the camshaft. Remove the tappets with adjusting washers. The tappets should be...

Checking the camshaft
The camshaft should not show any obvious signs of wear. If the cams are clearly worn or have flattened tips, the shaft must be replaced. Below are the main parameters of...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Fiesta 4
Fiesta 2