Car engine ignition system Ford Fiesta 2

Description of ignition control
The engine uses an electronic ignition system without a distributor. The following sensors are used to control the ignition: engine speed, coolant temperature and...

Replacing the coolant temperature sensor
Disconnect the ground cable from the battery. If necessary, eliminate the increased pressure in the cooling system. To do this, very carefully and gradually open the...

Removing and installing the ignition coil
Disconnect the ground cable from the battery. Remove the multi-pin connector plug from the coil socket (Fig. 2.150). Remove the high voltage connector plug hooks and...

Removing and installing the engine speed sensor
Disconnect the ground wire from the battery clamp. Remove the multi-pin connector plug from the sensor (Fig. 2.153). Screw in the mounting bolt and remove the sensor...

Ignition and injection control system in 1.4i/1.6i engines
Fig. 2.155 shows the electrical connections of the ignition system and fuel injection system. The ignition advance control pulses are generated in the ignition...

Removing and installing the ignition distributor
Disconnect the ground wire from the battery clamp. Remove the wire from the coil side that connects it to the ignition distributor. Remove the distributor cap. Removal...

Removing and installing the ignition control module
Disconnect the ground wire from the battery clamp. Remove the multi-pin connector plug from the module socket (Fig. 2.159). Unscrew the fastening bolts and remove the...

Spark plugs and starting plugs
Spark plugs play a very important role in terms of the proper functioning of the engine. Always use only recommended candles: for 1.1 engine with exhaust gas discharge...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Fiesta 4
Fiesta 2