Starter Interlock Switch Adjustment

This adjustment is made with the gearbox removed from the vehicle and the valve cover removed. Set selector lever to position «N». Insert a drill ∅ 2.3 mm into the opening of the switch housing and, turning the switch housing, as shown in Figure 3.49, align the housing holes with the inner hole.



Insert the drill bit to hold the switch body and tighten the switch housing. Install the shift control valve lever and attach the return spring. Install the valve box cover with a new gasket, making sure that the box data plate has not come off. Install oil filler pipe (pic. 3.50) with a new seal. Remove the gearbox from the stand.



Install the oil pump drive shaft and torque converter.