Car rear suspension Ford Escort 3
Features of the device
The rear suspension (Fig. 4.10) is independent, with transverse levers and longitudinal struts, with hydraulic telescopic shock absorbers and a coil spring. Fig. 4.10....
The rear suspension (Fig. 4.10) is independent, with transverse levers and longitudinal struts, with hydraulic telescopic shock absorbers and a coil spring. Fig. 4.10....
Rear wheel alignment angles
The rear wheel toe-in angles are adjusted at the factory by selecting adjusting washers 16 ( fig. 4.10 ), the toe-in angle is not adjusted during operation, and the...
The rear wheel toe-in angles are adjusted at the factory by selecting adjusting washers 16 ( fig. 4.10 ), the toe-in angle is not adjusted during operation, and the...
Removing and installing the rear suspension assembly
Place the vehicle on stands and disconnect the parking brake cable. Loosen the bolts securing the tie rod and suspension arm to the body. Disconnect the brake hoses from...
Place the vehicle on stands and disconnect the parking brake cable. Loosen the bolts securing the tie rod and suspension arm to the body. Disconnect the brake hoses from...
Removing and installing the suspension spring
Place the rear of the car on stands and remove the wheel from the desired side. Place a jack under the lower support cup of the suspension arm spring. Remove the plastic...
Place the rear of the car on stands and remove the wheel from the desired side. Place a jack under the lower support cup of the suspension arm spring. Remove the plastic...
Replacing the shock absorber
Place the rear of the car on stands and remove the wheel mounting bolts on the desired side. Place a jack under the suspension arm. Remove the plastic cap under the rear...
Place the rear of the car on stands and remove the wheel mounting bolts on the desired side. Place a jack under the suspension arm. Remove the plastic cap under the rear...
Removing and installing the suspension arm
Place the rear of the vehicle on stands. Place the jack under the lower spring support cup on the suspension arm. Remove the suspension arm-to-body mounting bolt. Remove...
Place the rear of the vehicle on stands. Place the jack under the lower spring support cup on the suspension arm. Remove the suspension arm-to-body mounting bolt. Remove...
Removing and installing the stretch
Place the car on stands, unscrew the nuts of the front, then the rear strut mount, noting the number and location of the washers and bushings. The installation of the...
Place the car on stands, unscrew the nuts of the front, then the rear strut mount, noting the number and location of the washers and bushings. The installation of the...
Removing and installing the hub
Place the rear of the car on stands and remove the wheel from the desired side. Remove the cap 8 ( fig. 4.12 ) hubs, remove cotter pin 9, unscrew nut 6 and remove the...
Place the rear of the car on stands and remove the wheel from the desired side. Remove the cap 8 ( fig. 4.12 ) hubs, remove cotter pin 9, unscrew nut 6 and remove the...
Replacing hub bearings
Remove seal 4 and inner bearing from the removed hub. Using a drift, strike alternately at opposite points to knock out the outer bearing rings. Clean the hub. Using...
Remove seal 4 and inner bearing from the removed hub. Using a drift, strike alternately at opposite points to knock out the outer bearing rings. Clean the hub. Using...
Removing and installing the trunnion
Place the rear of the vehicle on stands and remove the wheel from the desired side. Remove the drum and brake shield. Jack up the suspension arm. Tighten the nut and...
Place the rear of the vehicle on stands and remove the wheel from the desired side. Remove the drum and brake shield. Jack up the suspension arm. Tighten the nut and...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
See other similar sections for Ford cars:
• Chassis: Rear suspension Ford Focus 2 (2004-2010)
• Chassis: Rear suspension Ford Mondeo 2 (1997-2000)
• Suspension and chassis: Rear suspension Ford Fiesta 2 (1983-1989)
• Chassis: Rear suspension Ford Focus 2 (2004-2010)
• Chassis: Rear suspension Ford Mondeo 2 (1997-2000)
• Suspension and chassis: Rear suspension Ford Fiesta 2 (1983-1989)
Escort 5
Escort 4
Escort 3
- General information
- User manual
- Maintenance
- Engine
- HCS and Endura-E engines
- CVH and PTE engines
- Zetec and Zetec-E engines
- Gasoline engines
- Diesel engines
- Diesel engines (since 1992)
- Cooling and heating
- Carburetors
- CFI fuel injection
- EFI fuel injection
- SEFI fuel injection
- Exhaust system
- Charging and starting system
- Ignition system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Electrical equipment
- Light and appliances
- Schematic diagrams
Escort 4
- General information
- User manual
- Maintenance
- Gasoline engines
- OHV engine repair
- CVH engine repair
- Fuel system
- Weber 2V carburetor
- KE-Jetronic injection system
- CFI injection system
- Ignition system
- Diesel engines
- Engine repair
- Fuel system
- High pressure pump
- Cooling and lubrication system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis
- Suspension and wheels
- Steering
- Brake system
- Body
- Body elements
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Lighting system
- Electrical circuits
Escort 3
- General information
- Maintenance
- Characteristics
- Engine
- Disassembly and assembly
- Cooling system
- Lubrication system
- Supply system
- Fuel injection «K-Jetronic»
- Transmission
- Clutch
- Mechanical gearbox
- Hydromechanical box
- Drive shafts
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Electrical equipment
- Starting and charging system
- Ignition system
- Ignition «Escort RS 1600»
- Light and appliances
- Schematic diagrams