CVH and PTE engines of vehicle Ford Escort 5

Technical specifications
Engine type - four cylinders with overhead valves. Engine code: CVH 1.4 dm³ engine: models with carburetor - FUH models with CFI fuel injection system - F6F Engines RTE...

General information
This section of Chapter 2 covers repair operations performed on the engine installed in the vehicle. Information regarding engine/transmission removal and...

Top dead center (TDC) of the piston of the first cylinder
The top dead center (TDC) of a piston is the point through which each piston passes as the crankshaft rotates. Each piston reaches the TDC position at the end of the...

Cylinder head cover
Removal Remove the ground cable from the battery. Remove the air supply system and air filter where necessary. Remove the crankcase ventilation hose from the head cover....

Valve clearances
Setting the valve clearances correctly is very important because they largely determine the performance of the engine. If the valve clearances are too large, the engine...

Crankshaft pulley
Removal Remove the ground cable from the battery. Raise the front of the vehicle and support it on stands. Unscrew the bolt and remove the cover from the back of the...

Timing Belt Cover
Removal Remove the ground cable from the battery. Remove the two bolts securing the power steering pipe support brackets and move the pipe away from the upper housing....

Toothed belt
Removal Remove the ground cable from the battery. Loosen the lower mounting bolts, unscrew the upper tension bolt of the generator. Tilt the generator toward the engine...

Timing Belt Tensioner and Pulleys
Timing Belt Tensioner Mechanism Turn the engine crankshaft until the marks on the camshaft pulley and cylinder head, as well as on the crankshaft pulley and oil pump...

Replacing the camshaft sealing ring
Remove the camshaft pulley. The camshaft seal ring is now accessible for removal. Using a suitable screwdriver or hook-end tool, remove the seal ring from its seat (see...

Camshaft, levers and tappets
Removal Remove the ground cable from the battery. Remove the upper timing belt cover and head cover. On carburetor engines, remove the fuel pump. On RTE engines, remove...

Cylinder head
Removal One of the reasons for removing the cylinder head may be replacing the gasket. The presence of defects in the gasket is indicated by a loss of engine power, a...

Oil pan
Removal Remove the ground cable from the battery. Drain the engine oil. Refit the oil pan drain plug. Raise the front of the vehicle and support it on stands. Remove the...

Oil pump
Removal Remove the ground cable from the battery. Remove the accessory drive belt. Remove the crankshaft pulley, timing belt cover, timing belt, crankshaft timing...

Disassembling the oil pump
Disassembly Remove the pump from the engine. Unscrew the mounting screws and remove the pump cover. Remove the O-ring (see Fig. 2B.51). Examination Clean the rotors and...

Crankshaft sealing rings
Replacing the front sealing ring Remove the ground cable from the battery. Loosen the lower mounting bolts, unscrew the upper tension bolt of the generator. Tilt the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Escort 5
Escort 4
Escort 3