Install the drum-hub and outer bearing. Install the washer, tighten the nut and seat the hub on the inner bearing, rotating the drum and tightening the nut to a torque of 2.0-2.5 kgf·m.
Loosen the nut by 180° and tighten it by hand so that the slots align with the hole in the journal, and insert the cotter pin without changing the position of the nut. Install a new cotter pin and cap.
Adjusting the tightening of the hub bearings
Tighten the nut with a torque of 2.0–2.5 kgf·m. Loosen the nut by 180° and tighten it by hand, install stopper 7, a new cotter pin and cap.
The original article is available on the website FORDBOOK.ru