Car engine cooling system Ford Scorpio 1
Technical characteristics of the cooling system
The cooling system is a sealed type and includes a radiator, expansion tank, coolant pump, thermostat and fan. On vehicles with auxiliary signaling system, the expansion...
The cooling system is a sealed type and includes a radiator, expansion tank, coolant pump, thermostat and fan. On vehicles with auxiliary signaling system, the expansion...
Draining the coolant
Warning: When opening the expansion tank cap on a hot engine, care must be taken as hot fumes may escape and cause severe burns. Warning: Do not allow coolant to come...
Warning: When opening the expansion tank cap on a hot engine, care must be taken as hot fumes may escape and cause severe burns. Warning: Do not allow coolant to come...
Flushing the cooling system
1. Disconnect the upper hose from the radiator. 2. Insert a hose into the radiator and flush with a stream of clean water until the water flows out of the radiator drain...
1. Disconnect the upper hose from the radiator. 2. Insert a hose into the radiator and flush with a stream of clean water until the water flows out of the radiator drain...
Filling the cooling system
1. Screw in the drain plugs in the radiator. 2. Fill the cooling system through the filler hole of the expansion tank with the recommended amount of coolant. 3. Connect...
1. Screw in the drain plugs in the radiator. 2. Fill the cooling system through the filler hole of the expansion tank with the recommended amount of coolant. 3. Connect...
Removal and installation the radiator
Fastening the lower radiator hoses, transmission oil cooling element and hose to the expansion tank A – fastening of the lower radiator hoses, B – transmission oil...
Fastening the lower radiator hoses, transmission oil cooling element and hose to the expansion tank A – fastening of the lower radiator hoses, B – transmission oil...
Removal and installation the thermostat
OHC engines Coolant pump and thermostat OHC engine 1 – thermostat housing, 2 – gasket, 3 – sealing ring, 4 – thermostat, 5 – spring clamp, 6 – pump impeller, 7 – gasket,...
OHC engines Coolant pump and thermostat OHC engine 1 – thermostat housing, 2 – gasket, 3 – sealing ring, 4 – thermostat, 5 – spring clamp, 6 – pump impeller, 7 – gasket,...
Removal and installation a fan with a hydraulic clutch
Engine Radiator Fan OHC 1 – hydraulic fan clutch, 2 – fan blades, 3 – generator, 4 – belt, 5 – fan pulley, 6 – crankshaft pulley Key for unscrewing the fan clutch...
Engine Radiator Fan OHC 1 – hydraulic fan clutch, 2 – fan blades, 3 – generator, 4 – belt, 5 – fan pulley, 6 – crankshaft pulley Key for unscrewing the fan clutch...
Removal and installation an electric fan
1. Disconnect the ground wire from the battery. 2. To provide additional working space when removing the cooling fan shroud (which is removed from underneath the...
1. Disconnect the ground wire from the battery. 2. To provide additional working space when removing the cooling fan shroud (which is removed from underneath the...
Coolant pump — removal and installation
OHC engines Removal 1. Disconnect the ground wire from the battery and drain the fluid from the cooling system. 2. Remove the fan together with the coupling. 3. Remove...
OHC engines Removal 1. Disconnect the ground wire from the battery and drain the fluid from the cooling system. 2. Remove the fan together with the coupling. 3. Remove...
Coolant temperature sensor
OHC Engine Temperature Sensor (manifold removed) DOHC Engine Temperature Sensor Location The DOHC engine temperature sensor (arrow) is located on the front side of the...
OHC Engine Temperature Sensor (manifold removed) DOHC Engine Temperature Sensor Location The DOHC engine temperature sensor (arrow) is located on the front side of the...
DOHC Engine Drive Belt
Drive Belt Condition Indicator Marks A – indicator mark, B – mark on the lever block Drive Belt Location on Power Steering Models 1 – power steering pump, 2 – generator,...
Drive Belt Condition Indicator Marks A – indicator mark, B – mark on the lever block Drive Belt Location on Power Steering Models 1 – power steering pump, 2 – generator,...
Drive belt tensioning mechanism
1. Remove the drive belt. 2. Remove the generator. 3. Unscrew the central mounting bolt and remove the tensioning mechanism. 4. Install the tensioner on the engine...
1. Remove the drive belt. 2. Remove the generator. 3. Unscrew the central mounting bolt and remove the tensioning mechanism. 4. Install the tensioner on the engine...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
See other similar sections for Ford cars:
• Power unit: Engine cooling Ford Focus 1 (1998-2004)
• Power unit: Cooling system Ford Mondeo 3 (2000-2007)
• Diesel engines: Cooling and lubrication system Ford Escort 4 (1986-1990)
• Engine: Cooling system Ford Fiesta 2 (1983-1989)
• Engine: Cooling system Ford Taurus 1 and 2 (1986-1994)
• Power unit: Cooling and heating Ford Transit 2 (1986-2000, diesel)
• Power unit: Engine cooling Ford Focus 1 (1998-2004)
• Power unit: Cooling system Ford Mondeo 3 (2000-2007)
• Diesel engines: Cooling and lubrication system Ford Escort 4 (1986-1990)
• Engine: Cooling system Ford Fiesta 2 (1983-1989)
• Engine: Cooling system Ford Taurus 1 and 2 (1986-1994)
• Power unit: Cooling and heating Ford Transit 2 (1986-2000, diesel)
Fusion
Scorpio 1
Scorpio 2
Sierra
- General information
- Vehicle device
- User manual
- Faults on the way
- Maintenance
- Tips for the car owner
- Power unit
- Engine repair
- Lubrication and cooling system
- Supply system
- Exhaust and vapor recovery
- Transmission
- Clutch
- Car gearbox
- Front wheel drives
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body
- Exterior
- Interior
- Doors, locks and windows
- Body сare
- Electrical equipment
- Equipment and devices
- Engine electrics
- Lighting and signaling
- Switches and sensors
- Electrical circuits
Scorpio 1
- General information
- User manual
- Maintenance
- Power unit
- Petrol engines OHC
- Petrol engines DOHC
- Petrol engines V6
- Ignition and control
- Diesel engines
- Cooling system
- Supply system
- Carburetors
- Fuel injection
- Transmission
- Clutch
- Manual gearbox «N»
- Manual gearbox «MT 75»
- Automatic gearbox «A4LD»
- Rear axle and drive shafts
- Chassis
- Steering
- Power steering
- Front suspension
- Rear suspension
- Brake system
- Body
- Exterior
- Interior
- Doors, locks and windows
- Heating and ventilation
- Electrical equipment
- Equipment and devices
- Power devices
- Electrical circuits
Scorpio 2
- General information
- Car care
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Ignition system
- Supply system
- Carburetors
- Injection system (gasoline)
- Injection system (diesel)
- Exhaust system
- Transmission
- Clutch
- Car gearbox
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body
- Exterior
- Interior
- Doors, locks and windows
- Heating system
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Windshield wipers and washers
- Power devices
- Electrical circuits
Sierra
- General information
- User manual
- Maintenance
- Gasoline engines
- Engine repair
- Ignition system
- Fuel system
- Cooling and lubrication system
- Changes 1984-1986
- Changes 1987-1989
- Changes 1990-1993
- Diesel engines
- Engine repair
- Fuel system
- Cooling and lubrication system
- Changes 1988-1993
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Cardan and rear axle
- Chassis
- Steering
- Steering with power steering
- Front suspension
- Rear suspension
- Brake system
- Body and electrical
- Body elements and doors
- Electrical equipment
- Electrical circuits