Exterior (external body parts) Ford Fusion

Features of the body design
The body of Ford Fusion cars of the five-door station wagon type, load-bearing structure, all-metal. The body frame includes the base, side, roof and parts connected to...

Possible bodywork faults
Possible body malfunctions, their causes and methods of elimination

Removal and installation the radiator grille
The radiator grille is attached to the front edge of the bonnet with five nuts. You will need an 8mm socket head. 1. Open the hood and place it on the support. 2....

Removal and installation wheel mudguards and fender liners
The front and rear wheel arches are fitted with mudguards that protect the body from the abrasive effects of sand and stones thrown up by the wheels. Mudguards mounted...

Removal and installation the front bumper and its bar
You will need all the tools necessary to remove the front mudguards, as well as 10 and 13 mm socket heads and a flat-blade screwdriver. 1. Disconnect the wire from the...

Removal and installation the rear bumper
You will need: all the tools needed to remove the rear mudguards (see " " Removal and installation trunk trims "), as well as an 8 mm socket head, a Phillips-head...

Removal and installation the front wing
You will need: a wrench and a 10 mm socket head. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the mudguard… 3. …and the front fender liner...

Removal and installation the air intake box grille
The air intake box grille is removed if it is damaged or to gain access to the windshield wiper, as well as when replacing the windshield glass. You will need a...

Removal and installation the hood
You will need: a 10 mm socket head and a flat-blade screwdriver. Note: To avoid injury and damage to vehicle parts, remove the hood with an assistant. 1. Open the hood...

Removal, installing and adjusting the hood lock
You will need: 10 and 13 mm wrenches, a 10 mm socket head, and a flat-blade screwdriver. To remove the hood lock do the following. 1. Open the hood and place it on the...

Removal and installation the outside mirror
You will need: a 10 mm socket head, a TORX T25 key, and a flat-blade screwdriver. Note: The left power outside mirror is shown being removed. The right mirror and both...

Removal and installation the battery shelf bracket
The battery mounting shelf is removed for replacement if it is damaged and to gain access to other vehicle components. You will need: 10 mm keys, TORX T25, 13 mm socket...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Fusion
Scorpio 1
Scorpio 2
Sierra