Mechanical gearbox type «MT 75» car Ford Scorpio 1

Technical characteristics of the mechanical gearbox type «MT 75»
The gearbox is a three-shaft, classic design, has five synchronized gears for forward movement (4th gear is direct) and a synchronized reverse gear. The gearbox is...

Description of the design of the mechanical transmission type «MT 75»
Gearbox MT 75

Removal the gearbox
Gearbox to beam mounting bolt The mounting bolt is indicated by the arrow. Speedometer drive mounting retaining ring The retaining ring is indicated by the arrow....

Gearbox installation
Installation 1. Pull the clutch release forks back and secure them in this position with wire. 2. Apply a thin coat of Ford special grease (No. 5021439) to the input...

Gearbox housing — design description
Gearbox housing 1 – clutch housing, 2 – gearbox housing, 3 – oil filler plug, 4 – oil drain plug, 5 – release bearing guide sleeve, 6 – intermediate shaft bearing...

Gear shift mechanism — design description
Gear shift mechanism, gearbox type MT 75 1 – axle forks 3–4 gears, 5th gear and reverse gear, 2 – axle forks 1–2 gears, 3 – forks 3–4 gears, 4 – forks 5th gear and...

Disassembling the gearbox
Front view of the clutch housing 1 – nut fixing plate, 2 – intermediate shaft bearing nut Removal the clutch release bearing guide sleeve 1 – special device Ford 16.040...

Gearbox gears and shafts — design description
Shafts and gears of the mechanical gearbox type MT 75 1 – needle bearing, 2 – snap ring, 3 – bearing, 4 – primary shaft, 5 – synchronizer ring, 6 – needle bearing, 7 –...

Replacing bearings in the gearbox
Control dimension of the selector end position 1. Using an inertial puller, remove the bearing (3) (see Fig. Shafts and gears of the mechanical gearbox type MT 75 )...

Checking the reverse gear pinion shaft
1. Using a suitable rod, remove the reverse gear pinion axle mounting pin. 2. Remove the bearing support sleeve, reverse gear idler gear and needle bearing from the...

Primary and secondary shafts — disassembly and assembly
Removal the 5th gear pinion, 5th gear synchronizer ring and needle bearing from the secondary shaft 1 – secondary shaft of 5th gear pinion, 2 – 5th gear synchronizer...

Gearbox assembly
1. Insert the 1-2 gear fork axle onto the 1-2 gear synchronizer slip clutch on the secondary shaft. 2. Assemble the intermediate and secondary shafts and hold this unit...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

See other similar sections for Ford cars:
• Power unit: Mechanical gearbox MTX-75 Ford Focus 1 (1998-2004)

Fusion
Scorpio 1
Scorpio 2
Sierra