Checking the reverse gear pinion shaft (Scorpio 1)

1. Using a suitable rod, remove the reverse gear pinion axle mounting pin.

2. Remove the bearing support sleeve, reverse gear idler gear and needle bearing from the axle.

3. Check the status of the extracted elements.

4. Place the needle bearing, reverse gear idler gear and bearing support sleeve onto the axle.

5. Install a new dowel pin.

6. Using a screwdriver, remove the sealing ring from the release bearing guide sleeve.

7. Install a new sealing ring using a rod of the appropriate diameter; the sealing edge must be directed towards the rod.

The original can be found on the specified resource: fordbook.ru