Brake system of the car Ford Scorpio 2

General information about the braking system
The brake system consists of a master brake cylinder, a brake booster, and disc brakes on the front and rear wheels. The hydraulic brake system has 2 circuits. One brake...

Anti-lock braking system (ABS)
FORD SCORPIO vehicles are equipped with an anti-lock braking system (ABS) as standard. FORD SCORPIO models up to 1/92 are equipped with TEVES MK II ABS brakes. From...

Front Disc Brake Caliper
A - guide pins with polymer thread coating B - brake shoe guide C - retaining bracket D - brake pads E - dust cuff F - piston seal G - piston H - piston body

Removal and installation front disc brake pads
Removal The position of the front wheels on the capitals is marked with paint. Thanks to this, the balanced wheel can be installed again in the previous position. When...

Rear Disc Brake Caliper
A - piston body B - mounting bolt C - air bleed valve D - guide pin E - dust cuff F - adjusting bolt G - lock washer H - piston J - finger K - return spring L - rocker...

Removal and installation rear disc brake pads
To remove and install the rear brake pads, you will need a special FORD 12-006 tool for installing the piston in the wheel brake cylinder. Installation Mark the position...

Checking the thickness and lateral runout of brake discs
Note: All models have internally cooled air-cooled brake discs at the front axle. TURNIER and 2.9L 24-valve models have internally cooled air-cooled brake discs at the...

Brake shoe guide with front brake caliper
Attention: For vehicles with the TEVES MK II brake system, it is necessary to create pressure in it before opening it. To do this, turn the key in the ignition switch to...

Brake shoe guide with rear brake caliper
Attention: For vehicles with the TEVES MK II brake system, it is necessary to create pressure in it before opening it. To do this, turn the key in the ignition switch to...

Removal and installation the brake disc
To ensure uniform braking on both sides, both brake discs must have identical surfaces in terms of wear pattern and unevenness depth. Therefore, both brake discs must be...

Checking the brake booster
Brake system TEVES MK IV The brake booster should be checked if an unusually high force must be applied to the brake pedal to achieve sufficient braking effect. Start...

Replacing the brake line and hose
Pipes are used for the connections of the brake system, which, along with high-pressure brake hoses, provide a connection between the master brake cylinder and the four...

Brake fluid — safety precautions
When handling brake fluid, the following requirements must be met. Safety instructions: Brake fluid is poisonous. Never suck brake fluid out with your mouth through a...

Bleeding air from the hydraulic brake system
After each brake repair, when the hydraulic system is opened, air gets into it. This air must be removed from the brake system. If there is air in the brake system, the...

Adjusting the handbrake
The rear axle brakes are adjusted automatically depending on the wear of the brake pads. Therefore, the handbrake adjustment is only necessary after replacing the...

Removal and installation the handbrake cable
Removal Mark the position of both rear wheels on the hubs with paint. This will allow the balanced wheel to be installed again in the same position. Loosen the wheel...

Removal and installation the brake light switch
Cars up to 8/94 Removal Attention. For vehicles equipped with a cruise control system, the speed control system must be reconfigured after replacing the brake light. In...

Technical characteristics of the brake system
Technical characteristics of the brake system Model All except TURNIER 2.9 l, 24 valves Front brake discs Outer diameter, mm 260 260 278 Thickness of new brake disc, mm...

Brake fault diagnostics
Brake fault diagnostics

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Fusion
Scorpio 1
Scorpio 2
Sierra