Vehicle switches and sensors Ford Fusion

Replacing the external lighting control unit
1. Disconnect the wire from the negative terminal of the battery. 2. Open the small items drawer… 3. …lift it up… 4. …and remove from the installation location. 5. In...

Replacing the instrument panel switches
1. Disconnect the wire from the negative terminal of the battery. 2. Remove the car radio from the center console of the instrument panel (see " Removal and installation...

Replacing the hazard warning switch
1. Disconnect the wire from the negative terminal of the battery. 2. Remove the car radio (see " Removal and installation a car radio "). 3. From the inside of the...

Replacing the control unit for exterior mirrors
You will need a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Carefully pry up the outside mirror control unit with a...

Replacing the electric trunk lock switch
1. Disconnect the wire from the negative terminal of the battery. 2. Open the small items drawer… 3. …lift it up… 4. …and remove the box. 5. In the resulting opening,...

Checking and replacing the fuel level indicator sensor
The fuel level indicator sensor is installed on the fuel module. To check the sensor you will need an autotester. 1. Disconnect the wire from the negative terminal of...

Replacing the pressure sensor in the power steering system
The power steering pressure sensor is screwed into the housing of the power steering pump pressure line. You will need a 13 mm wrench. 1. Disconnect the wire from the...

Checking and replacing the reverse light switch
The reverse light switch is installed in the upper part of the gearbox housing. You will need a 22 mm wrench. 1. Disconnect the wire from the negative terminal of the...

Replacing the brake light switch
The brake light switch is mounted on the pedal assembly bracket and is located above the brake pedal. 1. Disconnect the wire from the negative terminal of the battery....

Replacing the clutch pedal position sensor
The clutch pedal position sensor is mounted on the pedal assembly bracket and is located above the clutch pedal. When the clutch pedal is pressed, the sensor transmits a...

Replacing the brake pedal position sensor
The brake pedal position sensor is mounted on the pedal assembly bracket and is located above the brake pedal. 1. Disconnect the wire from the negative terminal of the...

Replacing the Parking Brake Indicator Light Switch
You will need: an 8 mm spanner and a flat-blade screwdriver. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the floor tunnel lining (see "...

Replacing the fuel switch
When the vehicle rolls over, the switch that supplies voltage to the fuel pump is activated and the fuel supply is stopped. When the switch is triggered, press on the...

Replacing wheel speed sensors
To replace the front wheel speed sensors you will need an 8 mm wrench. Note: In this subsection, replacing the front wheel speed sensors is described using the left...

Replacing the shock sensor
You will need a TORX T25 key. 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the B-pillar trim (see " Removal and installation of interior...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

See other similar sections for Ford cars:
• Electrical equipment: Switches and sensors Ford Focus 2 (2004-2010)

Fusion
Scorpio 1
Scorpio 2
Sierra